What have you done to your square lately??

[The88]

Cool, I was trying to find a 30psi gauge. They seem to be 15 or 60. I was worried about potential leaks there. I see yours is 15?

Roger 15. I didn't feel the need for a 60.

CFM Technologies

CFM Technologies sells and manufacturers Magazine + TV Featured performance parts for GM TBI , Throttle Body Injection, along with custom carburetor spacers and the famous HVH Super Sucker Carb Spacers.

marine-performance-parts.com

 

[Ajax19]

Some progress Remade the front brackets going to use some 1/4" scrap to make some gussets still need to drill some holes but my old drill bit the dust so I'm waiting on one to show up got a few more gussets to make for the rear 2x3 flatbed frame rail and some to the rear bumper to frame

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

 

[mtbadbob]

I got this seat cover and installed it. VERY VERY NICE.

You must be registered for see images attach

Love the charcoal interior! Who's cover is that?

 

[Ajax19]

Also got more 5/8" hardware to upgrade the 1/2" on the truck, old vs New brackets, another hitch receiver I'm going to add below the existing one is too high but it is good for my hitch mounted accessories (crane and eventually a vise)

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

 

[Tank6x2]

Took the weekend to flush the welds on the rocker, yes Overkill on the tack welds - pulling straight little warpage from the alteration after the fact. That and a hand to remove my hood thrown in the box and then fastening the cowl support down - not 100% yet - hope everyone is getting lots done since the new year started!