What have you done to your square lately??

[WFarm]

Last week when I was putting my dash back together I realized I had overlooked that I was missing the short section of expandable ductwork that connects the far right air register to the rest of the ductwork. Apparently it had been removed at some point and never reinstalled. I ordered one from LMC and installed it today.

You must be registered for see images attach

You must be registered for see images attach

 

[Camar068]

All black again. 2K up next.

You must be registered for see images attach

time to wet sand by hand?

 

[TotalyHucked]

Last week when I was putting my dash back together I realized I had overlooked that I was missing the short section of expandable ductwork that connects the far right air register to the rest of the ductwork. Apparently it had been removed at some point and never reinstalled. I ordered one from LMC and installed it today.

You must be registered for see images attach

You must be registered for see images attach

That's good to know they carry the ducting. Last I knew, nobody did

 

[82sbshortbed]

New air filter came yesterday. So new filter and painted lid are on now. Much better.

You must be registered for see images attach

 

[idahovette]

^^^^^your ribs are going the wrong way...........air resistance...........lol.....looks good tho^^^^^^^

 

[Chevrolado]

Agreed.. point those puppies forward. +5hp at least.

 

[DoubleDingo]

@82sbshortbed Don't listen to them, it's perfect that way it is

 

[ChuckN]

@82sbshortbed Don't listen to them, it's perfect that way it is

Well, I’m against the grain. Put them diagonal.

 

[Chevrolado]

Some people just want to watch the world burn...

 

[brooksman9]

Flip it upside down. 10 hp.

 

[bluex]

Well, I’m against the grain. Put them diagonal.

Could cause the front end to pull from uneven airflow though

 

[WFarm]

That's good to know they carry the ducting. Last I knew, nobody did

Only place I could find that had these pieces.

 

[82sbshortbed]

Flip it upside down. 10 hp.

I'd say at least 12 on the big block lol

You must be registered for see images attach

Beed to repaint that one too.lol

 

[Drauka99]

I got the old u-joints pressed out of the driveshaft, new one purchased for the NV3500 swap. Also got the driveshaft and transmission crossmember cleaned up and painted. Installed the new flywheel and clutch and pressure plate. also replaced the throw-out bearing in the trans. Also zip tied some un-needed wiring out of the way and prepping for putting the tans in place this weekend.