newguy11
Full Access Member
- Joined
- Aug 24, 2021
- Posts
- 80
- Reaction score
- 146
- Location
- New England
- First Name
- Private
- Truck Year
- 1972-1987
- Truck Model
- C/k 10
- Engine Size
- 305/350
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
They are talking about a car with a motor plate and they are talking about the bolt hole you can use to hold the fuel pump pushrod. But that is a valid point. Make sure the bolt hole that intersects the fuel pump pushrod has a bolt in it.
The pvc valve is not clogged up. I can blow thru it. It seems good
Excess blow by may be forcing oil out breather, follows down the valve cover by fan/angle.Gentlemen, I have been chasing an oil leak on a 86 350. I have replaced the rear main seal, oil pan gasket and the intake gasket. I have also replaced the dipstick tube just in case. Still have a leak somewhere and not sure where to go from here. The oil seems to be coming from the passenger side around the starter location. Any ideas or suggestions?