GMC-IH

[DoubleDingo]

The way I removed them is with a punch ..
Hammer on one side to get them tilted in the bore then with vice grips pull them out of the block ..
A few of them was so rusted that the punch broke though the wall ..

Most certainly they was going to leak in a very short time if they wasn't replaced ..
Always do a replacement when rebuilding a motor .. Save a bunch of grief down the road ..

And easy insurance for a very long time especially with the replacements being brass.

 

[legopnuematic]

Agree on changing freeze plugs, because it’ll never be the one that’s easy to get to that starts leaking.

Always be on the back of the block or behind the motor mounts.

 

[squaredeal91]

I've learned on my own rigs the value of the brass ones. I've replaced rotten leaking steel plugs after only 8 years.

 

[dragstews]

You must be registered for see images attach

 

[dragstews]

Changing out the power steering pump reservoir ..
Didn't like it tilting that much ...
Soon to see if I helped the cause or made it worse ?

 

[dragstews]

Plumbed the oil sending unit ..
It's the og 1954 IH, keeping all the stock gauges on line ...

You must be registered for see images attach

After all these years they still work ..

You must be registered for see images attach

 

[dragstews]

Changing out the power steering pump reservoir ..
Soon to see if I helped the cause or made it worse ?

You must be registered for see images attach

I like this look much better ...

 

[dragstews]

Been spending some time on the homemade dipstick ...

You must be registered for see images attach

Not all that sure it's going to workout the way I got it pictured in me head at the moment .. ??

You must be registered for see images attach

Some more bending might get it to the look I'm after .. ??

You must be registered for see images attach

 

[dragstews]

Reworked the tube by adding another bend ..

You must be registered for see images attach

Tried a few inner sticks ..

You must be registered for see images attach

This one was too short by a few inches .

Got super lucky with finding one that was dead nuts on the money ..

You must be registered for see images attach

You must be registered for see images attach

6 qts in the pan put the cold full level mark in the middle of the zone ..
Did just a small amount of trimming to dial in the full level ..

Got super lucky without the need to get into a huge job ..

Next to do is to add some support brackets ..
... Dipstick is done ...

 

[dragstews]

You must be registered for see images attach

That was almost to dang easy !

'Ray Charles' could check and add oil to the "LS KILLER" motor now ...

xc_hide_links_from_guests_guests_error_hide_media