What have you done to your square lately??

WFarm · Tuesday at 6:25 PM

Last week when I was putting my dash back together I realized I had overlooked that I was missing the short section of expandable ductwork that connects the far right air register to the rest of the ductwork. Apparently it had been removed at some point and never reinstalled. I ordered one from LMC and installed it today.

You must be registered for see images attach

Camar068 · Tuesday at 6:35 PM

brooksman9 said:
All black again. 2K up next.

You must be registered for see images attach

time to wet sand by hand?

TotalyHucked · Wednesday at 9:06 AM

WFarm said:
Last week when I was putting my dash back together I realized I had overlooked that I was missing the short section of expandable ductwork that connects the far right air register to the rest of the ductwork. Apparently it had been removed at some point and never reinstalled. I ordered one from LMC and installed it today.

You must be registered for see images attach

You must be registered for see images attach

That's good to know they carry the ducting. Last I knew, nobody did

82sbshortbed · Wednesday at 9:36 AM

New air filter came yesterday. So new filter and painted lid are on now. Much better.

You must be registered for see images attach

idahovette · Wednesday at 10:23 AM

^^^^^your ribs are going the wrong way...........air resistance...........lol.....looks good tho^^^^^^^

Chevrolado · Wednesday at 10:40 AM

Agreed.. point those puppies forward. +5hp at least.

DoubleDingo · Wednesday at 11:40 AM

@82sbshortbed Don't listen to them, it's perfect that way it is

ChuckN · Wednesday at 11:58 AM

DoubleDingo said:
@82sbshortbed Don't listen to them, it's perfect that way it is

Well, I’m against the grain. Put them diagonal.

Chevrolado · Wednesday at 12:57 PM

Some people just want to watch the world burn... :bleh:

brooksman9 · Wednesday at 1:09 PM

Flip it upside down. 10 hp.

bluex · Wednesday at 1:14 PM

ChuckN said:
Well, I’m against the grain. Put them diagonal.

Could cause the front end to pull from uneven airflow though :shrug:

WFarm · Wednesday at 1:48 PM

TotalyHucked said:
That's good to know they carry the ducting. Last I knew, nobody did

Only place I could find that had these pieces.

82sbshortbed · Wednesday at 2:08 PM

brooksman9 said:
Flip it upside down. 10 hp.

I'd say at least 12 on the big block lol

You must be registered for see images attach

Need to repaint that one too.lol

Drauka99 · Wednesday at 4:09 PM

I got the old u-joints pressed out of the driveshaft, new one purchased for the NV3500 swap. Also got the driveshaft and transmission crossmember cleaned up and painted. Installed the new flywheel and clutch and pressure plate. also replaced the throw-out bearing in the trans. Also zip tied some un-needed wiring out of the way and prepping for putting the tans in place this weekend.

JamesSam · Wednesday at 8:53 PM

The TBI injectors and the pod got the spa treatment at my Nephews workshop today. Before

You must be registered for see images attach

After:

You must be registered for see images attach

What have you done to your square lately??

WFarm

Full Access Member

Camar068

Supporting Member

TotalyHucked

Full Access Member

82sbshortbed

Fuckemall!!

idahovette

Full Access Member

Chevrolado

Full Access Member

DoubleDingo

Full Access Member

ChuckN

Full Access Member

Chevrolado

Full Access Member

brooksman9

Full Access Member

bluex

Full Access Member

WFarm

Full Access Member

82sbshortbed

Fuckemall!!

Drauka99

Full Access Member

JamesSam

Full Access Member

Similar threads

Latest posts

Forum statistics