Craig Nedrow
Latest activity Postings About
-
-
I guess also check the rear cab mount bushings too. If they are falling apart, it could also cause the issue. -
With all due respect, you may just be wasting your time with that plan of attack. One of the major culprits of door sag is the door...
-
It looks to me like the focus is in the wrong area here. While the doors may be sagging slightly, the door/fender gap is FAR worse than...
-
Craig Nedrow reacted to EastAustinSawdust's post in the thread Sagging doors: where to start? with
Like.
Are you referring to the bushings between the frame and the body? Is there a specific bushing up front that you’re thinking of? Never... -
Inspect area around hinges for cracking of the door frame, especially upper hinge. If found will need to be repaired or door replaced...
-
Agree with the previous posts not a horrible job but huge improvement. I would recommend after that get new door striker and new nylon...
-
Craig Nedrow reacted to PrairieDrifter's post in the thread Sagging doors: where to start? with Like.
Replace all four hinge pins and bushings. Then adjust doors accordingly. You adjust them by loosening the bolts until they're just snug...
-
Open the door, grab the bottom corner and see if it moves up and down. Keep an eye on the hinge pins when you shake it. That is where...
-
Craig Nedrow reacted to TotalyHucked's post in the thread Huck's daily - 2005 Z71 crewcab with Like.
Cat-eye's and the '03-07 classic GMC's are tied as my favorites. This was my all time favorite vehicle (period, not just NBS) that I've...
-
Craig Nedrow reacted to Soundmound's post in the thread New daily project 2005 Silverado 2wd CCSSB with Like.
I repaired the rear defrost by plugging it back in on both sides. Detailer must have pulled them off? I threw in a set of weather tech...
-
Craig Nedrow reacted to TotalyHucked's post in the thread New daily project 2005 Silverado 2wd CCSSB with Like.
Nice score! Definitely a good little paw paw rig, should treat you well for a long time. Was gonna mention the side moldings, it's...
-
Craig Nedrow replied to the thread Fuel gauge to tachometer, clock to fuel gauge.I did this and did a write up, check it out if it helps, all good. Thats what we are here for. Start at post 69 page five. Link...
-
-
Craig Nedrow reacted to jh86's post in the thread Fuel gauge to tachometer, clock to fuel gauge with Like.
In a different approach, anyone aware of a small matching tach that goes in an empty small gauge location I have?
-
Craig Nedrow reacted to MPWILSON33's post in the thread Fuel gauge to tachometer, clock to fuel gauge with Like.
-
Craig Nedrow reacted to Camar068's post in the thread Fuel gauge to tachometer, clock to fuel gauge with Like.
LMC has gauges that will be a closer match. Stock gauges
-
-
Loading…
-
Loading…
