Lifter tick?

[chief_shotts]

Sbc 383 with a roller cam (#12-422-8) and hydraulic roller lifter (#17-5372-16). Noise is present during cold start and dissipates as engine warms up. No noise is noticed after engine is up to 160+ temp.
For reference the motor has less than 5k miles on it and i am using 10w-30 oil and oil pressure is up around 40 while idling.

I will be pulling valve covers today to inspect. I may also replace exhaust header gasket today as well to ensure its no just a exhaust leak.

Any input is appreciated.

Video link attached.

cold start

xc_hide_links_from_guests_guests_error_hide_media

starting to warm up

xc_hide_links_from_guests_guests_error_hide_media

 

[DoubleDingo]

Adjust the valves while you have the covers off. Use the two-roll method.

 

[DoubleDingo]

You must be registered for see images attach

You must be registered for see images attach

 

[legopnuematic]

Not critical to your issue/question at hand, but your valve cover spreader bars are on upside down.

 

[chief_shotts]

Not critical to your issue/question at hand, but your valve cover spreader bars are on upside down.

LOL. thanks for the heads up

 

[chief_shotts]

You must be registered for see images attach

Adjust the valves while you have the covers off. Use the two-roll method.

Thank you for the instructions. Ill try this next.

 

[chief_shotts]

You must be registered for see images attach

You must be registered for see images attach

Where did these images come from. Haines manual? whatever it is i should get one.

 

[legopnuematic]

But to the question at hand, check valves as @DoubleDingo shows, also note if any are loose, loose.

Check your header bolt tightness too, sometimes they loosen up (or gasket compresses) just enough to start leaking, then once heated up seals. Tighten them back up and leak goes away.

 

[DoubleDingo]

Where did these images come from. Haines manual? whatever it is i should get one.

Factory manual

 

[Camar068]

Not critical to your issue/question at hand, but your valve cover spreader bars are on upside down.

so the up tips of the bars need to be down? Never seen that.