Search results
-
How to soften 1983 k5 blazer original vinyl seats
You can wipe them down with baby oil or mineral oil/Murphys Oil Soap/Leather Softener/Conditioner or if you have some available saddle soap. Clean the seats first then rub the seats down and let them soak in the product. Then wipe off the excess. Wont be a miracle for tired seats but will make... -
455 Olds in place of 454 in 76 GMC (frame to engine mounts?)
You need the mounts from a 403 trans am. They use clamshells like a Chevy. Here are the brackets you need for the engine side. https://www.classicindustries.com/product/all-years/pontiac/firebird/parts/C269503.html Then use the Chevy clamshells on the frame. You may have to move them on the...- Magna86
- Post #41
- Forum: Tech Discussion
-
2005ish 6.2 LS3 complete 200$
It's probably a 6.0 LQ4 motor. Iron block LS2 basically..Great for LS swaps -
New truck... maybe. Should I?
We think why haven't you bought it yet! -
2005ish 6.2 LS3 complete 200$
Grab it and resell it. That's dirt cheap -
Never Ending Brake Bleeding
Adjust the rear brakes, doubled check lines are tight, can try just gravity bleeding and let the air work out, put speed bleeders on the wheel cylinders(all my car get them now), use mitty vac and or get a pressure bleeder setup.(can make one with a weed sprayer also google it) once you know...- Magna86
- Post #7
- Forum: Suspension, Steering & Brakes
-
Holes in roof. Any Ideas?
Plastic plugs with some silicone on them for a good seal -
Looking for a few things
Good Condition used. Unless good deal on new stuff -
Looking for a few things
Spare tire carrier And the top and bottom pieces of grille trim for my 74. -
455 Olds not lining up well in 76 GMC crew....
You need to run trans am 403 motor mount as this allows you to use the clamshell Chevy mounts. Not sure if the factory location is correct but you may need to move the mounts on crossmember forward or back to get right spot.- Magna86
- Post #25
- Forum: Engine & Performance
-
-
-
-
-
Oldsmobile Motor Mount Location
I know the F and A body cradles had different holes for different engine placement. The last motor this thing has was the Chevy 267 which is understand is about the same level as the Olds 260. I know the diesels had different mounts so we need someone who has access to one to see if the mounts...- Magna86
- Post #5
- Forum: Engine & Performance
-
Oldsmobile Motor Mount Location
Good Morning Everyone. Are there different locations on the engine cradle for the motor mounts? I'm swapping an Olds motor into my 74. I'm using the trans am mounts on the block so I can use the clamshell frame mounts. Does the Olds motor sit in the same place the 350 was? Sorry if I missed this...- Magna86
- Thread
- Replies: 5
- Forum: Engine & Performance
-
Factory Sway Bar Options
Went back and grabbed one. Added to the future install pile!- Magna86
- Post #35
- Forum: Suspension, Steering & Brakes
-
“What’s up with that old truck” Need help with identification!
Buy it now. Worth it all day!- Magna86
- Post #11
- Forum: Introduction
-
Factory Sway Bar Options
Well looks like I'll have to go back and grab a 4 door one then.- Magna86
- Post #32
- Forum: Suspension, Steering & Brakes
-
Factory Sway Bar Options
No I didn't. The 4 door bar would probably work as the 2 door but need to find different endlink as the ends are straight to bolt thru unlike the 2 door which are flat.- Magna86
- Post #27
- Forum: Suspension, Steering & Brakes
-
Factory Sway Bar Options
Well I struck out at pick in pull. All 4 door blazers. Now to check other yards- Magna86
- Post #19
- Forum: Suspension, Steering & Brakes
-
Factory Sway Bar Options
Well the pick n pull has a few S10 Blazers so time to go looking tomorrow!- Magna86
- Post #16
- Forum: Suspension, Steering & Brakes
-
What have you done to your square lately??
Went junkyard hunting and found a front sway bar with brackets. Cleaned up my parking and turn signal lenses for install. Remove the front turn signal housings to clean up and repaint for install. -
Factory Sway Bar Options
Got lucky and found a front sway. No luck on a rear on the suburbans.- Magna86
- Post #6
- Forum: Suspension, Steering & Brakes
-
