-
-
legozombie replied to the thread Engine Stalling - Bad EVAP/Charcoal Canister?.I am going to throw money at a new canister and a new PCV valve. I have part number 17061005BT so it's probably original and needs to... -
legozombie replied to the thread Engine Stalling - Bad EVAP/Charcoal Canister?.No bites yet from this crowd but in my research I found this image. It may be useful to someone out there.I don't know if it's exactly...
-
-
I tried doing some research and didn't find anything relevant so here is a new thread. There is a question at the end, I am just trying...
-
legozombie replied to the thread Door Jamb Switch Restoration.The only problem about buying new switches from what I gathered were the length of the actual switch or the threads not fitting the...
-
Have you thrown away parts because "they're cheap" or because you thought they were no longer useful or work cleaning? I just wanted to...
-
-
legozombie replied to the thread Parking Brake Light Not Coming On.So I tested the parking brake switch and it produced ground when it was supposed to just as our messiah and savior Paul Hitch intended...
-
-
legozombie replied to the thread Parking Brake Light Not Coming On.So I found sometime last week to do a quick test. The switch only had one wire that was brown/tan with a white stripe and it essentially...
-
-
The light should come on when one of the three tan/wht-33 wires is grounded. They are at ignition switch (when you start the truck)...
-
12v stab tester to parking brake switch, should be 2 wires. Once switch is depress, it should open the circuit to send 12v power to...
-
Good Evening. I am trying to trouble shoot my brake light not coming on on my dash. I have never seen it on once and never again. I have...
-
legozombie replied to the thread Need source for gauge backing housing w/clock.@Ron Craven I'm assuming this is the part you're looking for?
-
-
legozombie replied to the thread Need source for gauge backing housing w/clock.Duplicate msg sorry
-
legozombie replied to the thread Source for new gauge needles.I actually ran into a similar issue taking the gauge cluster off. I'm planning on having a friend 3d print some unique needles to fit...
-
legozombie replied to the thread Need source for gauge backing housing w/clock.Did you check truck and car shop? http://www.truckandcarshop.com/
-
-
Loading…
-
Loading…
