What have you done to your square lately??

[DoubleDingo]

@JamesSam this is a ridiculously easy radiator to replace. I had no idea how bad mine was until I actually pulled it out. It was leaking from several places.

And they still make quality copper brass units that are a direct fit and modifications required

 

[Oldbear42]

I loaded all the scarp mower parts for a run to the dump this weekend. We have built a few racing mowers in my shop, and I needed to clean up the failure pile before it got in the way of winter snow clearing.

 

[Normmus]

Loaded up the K10 with scrap metal today. I've been having issues with the divorced choke, not opening all the way. So I disconnected it and it ran way better on the highway, and used less fuel. I am going to try one of those electric conversions

 

[carfanatic63]

Been working on converting my GMC to actually have GMC badging.

Picked up a grille and clean tailgate panel for $130 from a swap meet and restored the grille.

Workong on restoring the tailgate panel right now too but no pictures of it

 

[Ajax19]

Been working on converting my GMC to actually have GMC badging.

Picked up a grille and clean tailgate panel for $130 from a swap meet and restored the grille.

Workong on restoring the tailgate panel right now too but no pictures of it

Dude score that's a hard to find grill

 

[carfanatic63]

Dude score that's a hard to find grill

What year is it exactly? '84?

I'm just curious since I've got a 76 with an 80s front clip. Figured this would hold me over until I do a front end swap in the future.

 

[Ajax19]

What year is it exactly? '84?

I'm just curious since I've got a 76 with an 80s front clip. Figured this would hold me over until I do a front end swap in the future.

83-84 there is one on eBay looks in worse shape for 400 right now so I think you got a deal

 

[Goldie Driver]

Noticed my turn signal/cruise stalk was loose. Looking thru old pics and noticed that there is a cut out in the lockplate that accepts a round tab from the plastic lock plate cover. Hmmm...

Looks big enough to get to the screw without taking the lockplate off.

Yup ! Still had to take the wheel off.

Dunno if it will hurt since the turn signal lever screw goes in to plastic but I put some blue loctite on it.

Bonus pics of horn spring, horn button (metal) and the plastic retainer, and the line up marks on the steering wheel and steering shaft.

 

[TotalyHucked]

Been working on converting my GMC to actually have GMC badging.

Picked up a grille and clean tailgate panel for $130 from a swap meet and restored the grille.

Workong on restoring the tailgate panel right now too but no pictures of it

Dude you stole that grille! Looks like it's got a couple broken slats but if repaired and fully restored, I've seen those go for $500-$1500

 

[carfanatic63]

Dude you stole that grille! Looks like it's got a couple broken slats but if repaired and fully restored, I've seen those go for $500-$1500

That's cool! Whenever I swap to the 70s front end, guess this could help fund it.

I'll post a pick this afternoon of it on the truck. Got it mounted yesterday but it's in the garage so I couldn't get a good picture

 

[GoingCustom]

Got the gooseneck hitch removed and holes cut where the down bars for the roll cage will get welded to