Rusty Nail
Full Access Member
- Joined
- Jan 29, 2015
- Posts
- 10,041
- Reaction score
- 10,134
- Location
- the other side of the internet
- First Name
- Rusty
- Truck Year
- 1977
- Truck Model
- C20
- Engine Size
- 350sbc
I say we keep drinkin.... I reckon Art is the expert.
Holley 4175 rebuild
- Thread starter maxtwms
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
maxtwms
Full Access Member
- Joined
- Jan 29, 2014
- Posts
- 170
- Reaction score
- 33
- Location
- Alabama
- First Name
- Max
- Truck Year
- 1985
- Truck Model
- K10
- Engine Size
- 305
EDIT: DUMB QUESTION. OBVIOUSLY IT FITS LIKE A GLOVE! PSHH EIGHT DOLLARS ***
OK I finally got this thing put back together but ended up with gas leaking from the transfer tube. I pulled out the o-ring and it was missing about an eighth of the ring. Not sure how that happened since I used the lithium grease and clearly drank enough to seat everything properly. In any case.. I wanted to replace that part but found theyre like $8 with or without shipping costs for just one. Thats pretty ridiculous..
Any chance I can't just use these?
https://www.homedepot.com/p/5-O-Rin...PIPHorizontal2_rr-_-100273592-_-100245761-_-N
I measured mine with calipers and get 1/4" tube OD but like .065" (.0025" off) thickness. Surely that's made up in the tolerance and the specs for the above o-ring are nominal/installed? Might be a duh question though..
OK I finally got this thing put back together but ended up with gas leaking from the transfer tube. I pulled out the o-ring and it was missing about an eighth of the ring. Not sure how that happened since I used the lithium grease and clearly drank enough to seat everything properly. In any case.. I wanted to replace that part but found theyre like $8 with or without shipping costs for just one. Thats pretty ridiculous..
Any chance I can't just use these?
https://www.homedepot.com/p/5-O-Rin...PIPHorizontal2_rr-_-100273592-_-100245761-_-N
I measured mine with calipers and get 1/4" tube OD but like .065" (.0025" off) thickness. Surely that's made up in the tolerance and the specs for the above o-ring are nominal/installed? Might be a duh question though..
Last edited:
Similar threads
