Gas tank installation help please

[ivangf]

Hello, i am new in the forum, i really like it, it is very nice.
I had to replace the driver side fuel sending unit. Now i am trying to install the tank back but it is very hard to connect the sending unit hoses cause there is no room for it.
Can somebody share a procedure to connect the sending unit hoses and install the tank without removing the bed?

Thank you for your support.

 

[Ricko1966]

I leave my hoses long and attached at the tank with clamps,with a second set of clamps loosely in place I pushup the tank,fish my hoses over,shorten as needed tighten my clamps with a 6 in 1 screwdriver with the tip removed, so its a nut driver. Of course you use new hose it is much more pliable and you can get the length you need.

 

[ivangf]

Hello Ricko, that is a good idea thank you very much, i will try it!

 

[RanchWelder]

It's tough to drop the tank and fix the lines without help and a way to jack the tank up at the same time.

 

[ali_c20]

Welcome from Austria.
As mentioned above longer fuel hose and a second set of hands.

 

[Ricko1966]

Hello Ricko, that is a good idea thank you very much, i will try

I can do them by myself,no jack if they are empty. If you are using new tanks new straps new brackets leave the straps just barely snug,push the forward end of the tank up start 1 bracket bolt use it as a pivot,push the other end up start a bolt get all bracket bolts in place then tighten the straps

 

[geolee]

I used a motorcycle jack it makes it a lot easier

 

[Camar068]

I used a motorcycle jack it makes it a lot easier

good reason to get one....use it for trans/transfer case as well. OI....found adapters to go on a normal hydraulic jack for a trans. Game changer for me...and cheaper.

 

[geolee]

Idk how well motorcycle jack would work on a lifted truck though. My truck sits pretty low so works perfect. Probably doing a transmission soon so maybe use it for that also. I lower everything lol my motorcycle is to low for the motorcycle jack

 

[Sgt Gus]

I used a transmission jack, you could do like ricko1966 said though. I left my hoses long enough from the tank on the ground and coiled when it went up.

 

[David King]

Welcome from the FL Panhandle!

 

[DonN]

Hello, i am new in the forum, i really like it, it is very nice.
I had to replace the driver side fuel sending unit. Now i am trying to install the tank back but it is very hard to connect the sending unit hoses cause there is no room for it.
Can somebody share a procedure to connect the sending unit hoses and install the tank without removing the bed?

Thank you for your support.

I install the fuel lines on the tank first then feed them over the frame. The sending unit wire should be long enough to connect it as the tank is going up. Once you have the tank bolted to the frame connect the ground and hook up the fuel lines.