exhaust question, heat riser valve connections

[spedigo]

putting a new engine in my 79 and finally got around to pulling the old one on Saturday. For the few months that I’ve had the truck it has had a pretty strong exhaust leak. Found out Saturday one of the reasons was because whoever installed it last didn’t use any manifold gaskets at all. so that along with all the other stuff, I’ve learned while working on it over the past few months, I can’t trust but what I take apart is anything close to what it should be.

so my question has to do with the manifold to crossover pipe connections, particularly the passenger side connection around the heat risers valve.

My heat riser is frozen in the open position so I’m just going to put it back in as is. What I would like to know is what exactly are the parts, donuts and gaskets, that I will need to ensure no leaks going forward?

fyi, the manifolds I am using have the integral donut shaped flange. I’ll put a picture below. Don’t know if there was a
gasket between the manifold and the heat riser when I pulled the engine. Also, what goes between the heat riser and the crossover pipe?

I know one side of the heat riser is flat and the other is shaped to fit a doughnut, but that’s about it.

You must be registered for see images attach