Dana 44 1/2-20 Studs

[LateOnTheBrakes]

Does anyone have a good part number for 1/2 studs for a Dana 44 front axle? I believe the truck should have 7/16 studs but all my wheels use 1/2. The dorman part number I have seen on other forums is 610-165 but it has been discontinued.

 

[AuroraGirl]

arent studs dont by size and spline? I cant imagine its the only application for that stud

 

[LateOnTheBrakes]

Probably. But my local part store people aren't very bright. I spend some time digging in their boxes of studs and found these that seem to fit the bill.

https://www.dormanproducts.com/p-11921-610-073.aspx

 

[RoryH19]

Probably. But my local part store people aren't very bright. I spend some time digging in their boxes of studs and found these that seem to fit the bill.

https://www.dormanproducts.com/p-11921-610-073.aspx

Old thread but about to do the same.
Did this dorman wheel stud work on the front?

 

[LateOnTheBrakes]

Yes, they worked.

 

[bucket]

Old thread but about to do the same.
Did this dorman wheel stud work on the front?

Thank you for finding this thread and bumping it up!!! I simply could NOT find where I had the part # written down.

 

[RoryH19]

Yes, they worked.

Great, thanks. I found them the other day at Autozone and saw your thread today.

 

[RoryH19]

Thank you for finding this thread and bumping it up!!! I simply could NOT find where I had the part # written down.

No problem. I was doing one last search before I pulled the wheels off.
I actually have the studs sitting on my desk.
I'll use 610-444 for my 14bSF 6 lug axle
This will give 1/2 all the way around.