Complete Interior Install

[FireTruck1984]

nice job! just finish one iv done last week!

@TPISly-C10 Looks great! I’m envious of your original seatbelts

 

[shinkle]

Auto Custom Carpets

New one piece carpet floor mats bought on ebay from autocarpets1 but made by Auto Customs Carpets

Carpet from LMC

You must be registered for see images attach

You must be registered for see images attach

 

[86c10twotone]

Looks fantastic!

 

[305_Square_Body]

From LMC but it was made by Dashes Direct

Mine didn’t fit. Still not screwed in on driver side.

 

[Rick76]

Mine didn’t fit. Still not screwed in on driver side.

You talking LMC $400ish metal-backed dashes? I used a preexisting hole in the truck's metal sub-dash (I think PO drilled it) to run a screw from the inside out into the backing of my LMC dash as I held it in place. That held enough to get it draped and molded perfectly around the instrument bezel and sitting firm with the sub-dash. I figure it will settle down once it gets some heat even if the screw lets go at some point.

 

[305_Square_Body]

You talking LMC $400ish metal-backed dashes? I used a preexisting hole in the truck's metal sub-dash (I think PO drilled it) to run a screw from the inside out into the backing of my LMC dash as I held it in place. That held enough to get it draped and molded perfectly around the instrument bezel and sitting firm with the sub-dash. I figure it will settle down once it gets some heat even if the screw lets go at some point.

I will give it another shot