Search results

  1. JimVG

    Tuff Country Lift Kit Experience

    Hello, I decided on a 2” lift because I wanted to use the narrow 285/75/16 on the factory 7” rims. This keeps the tire completely under the fender. It actually measured to be about a 3-1/2” lift combining the lift and the tires. Good luck, and please do your research if you are considering...
  2. JimVG

    Anti-Theft Security

    Vehicular theft in our area is at an all-time high, with an average of 81 cars/trucks being stolen daily in two neighboring Washington State counties. Many of these are older classics. I understand that nothing is an absolute solution, but I felt that I had to do what I can to thwart any effort...
  3. JimVG

    Warped/Bent/Bowed Rear Bumper

    I was able to correct most of the warp by manipulating combinations of the mounting bolts and brackets, and systematically ”adjusting” the shape of the bumper with a floor jack while the bumper was mounted on the truck. The metal is thin enough to allow cold forming in this manner. Worked for...
  4. JimVG

    Distributor bat terminal remote kill switch/

    I just installed the Painless Performance Remote Master Disconnect Kit 30206 on my 1978 K20. I removed the battery and battery support, and mounted the solenoid under the battery support. It cannot be accessed without removing the battery and support. I routed the wires back to the driver’s side...
  5. JimVG

    Warped/Bent/Bowed Rear Bumper

    I am experiencing problems with finding a new rear chrome bumper without impact strip for a 1978 K20. I am attempting to find a new bumper that is straight and level along the top, and devoid of any bends/warps and/or misshaped areas. I have purchased and returned (2) new bumpers; one from...
  6. JimVG

    Upper Heater Hose

    Thanks for the reply’s. It’s not the trans lines. They are below this port. I called the radiator shop that attempted to re-built it. The tech told me that this port is threaded for a plug when not in use. The 3/4” upper heater hose fits over the port and uses a standard clamp.
  7. JimVG

    Upper Heater Hose

    Hello, I just installed a new direct fit/replacement radiator with brass tanks on my 1978 K20. It’s a 350/auto with no air conditioning. The upper radiator hose connected to the radiator on the upper, passenger side. I attempted to have the original rebuilt, but it was too far gone and they...
  8. JimVG

    Pre-molded rubber fuel lines

    Thanks for the info.
  9. JimVG

    Pre-molded rubber fuel lines

    Hello, Does anyone know of a source for the two pre-molded rubber fuel lines that connect the hard lines to the fuel pump on a 1978 K10 5.7/350? I have found the “sidewinder” universal sections, but these are single plane bends. The factory hoses are dual plane bends (horizontal & vertical). I...
  10. JimVG

    33X12.5X15 Mud Terrain Tires

    I am running BFG All Terrain KO2’s - 285/75R16’s. They are narrower than the 33x12’s. They are relatively quite, but do pick up smaller rocks on gravel. Not enough of a detriment for me, as I really like the look of a tall, narrow tire on my truck.
  11. JimVG

    LED Conversion

    1978 K20. ORACLE Pre-Installed 7" H6024/PAR56 Sealed Beam Halo - Amber LED with ORACLE H4 - S3 LED Headlight Bulb Conversion Kit.
  12. JimVG

    How Will My Square Body Look With XX Lift and XX Tires?

    1978 K20 - 2” lift with BFG 285/75R16’s
  13. JimVG

    Tuff Country Lift Kit Experience

    Another major issue is that one of the included rear Tuff Country SX8000 shocks was completely locked in the compressed position, and could not be extended. I immediately reported this problem to Tuff Country, and the tech informed me a replacement shock would be shipped overnight. I received...
  14. JimVG

    Door Hinge Assembly Replacement

    Hello, I am about to replace all (4) door hinge assemblies on my 1978 K20 with new assemblies from LMC. I have researched the removal/installation process. Has anyone done a full replacement without removing the front fenders? Is this even possible? Thanks for your time and consideration. Jim
  15. JimVG

    Tuff Country Lift Kit Experience

    Thanks again for the reply's. Here is a pic of my 1978 Chevrolet K20 that I am installing this kit on. I will post a pic when completed.
  16. JimVG

    Tuff Country Lift Kit Experience

    Thank you to all who have taken the time to respond. Much appreciated. I woiuld like to clarify that my intention was not to post a rant about Tuff Country and/or Suspension Connection as companies, but simply to post my unfavorable experience in hopes that anyone else dealing with them might...
  17. JimVG

    Tuff Country Lift Kit Experience

    Hello, this is a bit long but detailed in hopes of saving someone else from the nightmare I am experiencing. When researching for recommendations for a quality lift kit for my 1978 K20 I discovered that Tuff Country was recommended consistently across popular square body sites, including this...

Latest posts

Forum statistics

Threads
44,173
Posts
950,869
Members
36,289
Latest member
HT2abbottrl
Top