Search results
-
-
Shop heater
Boiler that heats my house, 300ft away the residual heat that comes off the boiler and magic heat in the stack keep the shop nice and toasty, 40degree day plus I open doors windows lol -
This one needs to go, asking for opinions. Offering it up here first.
100% I'll rebuild/swap a motor way before putting bedsides Floorplan cab corners ect. -
Hi from IL
Welcome what parts of Illinois are you about I'm central.- 87scotty
- Post #12
- Forum: Introduction
-
-
-
-
Small block or Big block?
468 049s flat tops with hyd roller- 87scotty
- Post #28
- Forum: Engine & Performance
-
Popping noise between bed and cab when bouncing / turning
my front left corner of cab lifts off the frame lol- 87scotty
- Post #19
- Forum: Tech Discussion
-
Electric fuel pump suggestions - For Carburetor
i second this i run the in tank pumps and then a aeromotive bypass regulater been good 3 years and i pump alot of fuel lol- 87scotty
- Post #24
- Forum: Carb Fuel Systems
-
Popping noise between bed and cab when bouncing / turning
same! my rubbers look good as well but the mount will lift off the frame lol one day ill get them fixed hopefully before the cab falls off- 87scotty
- Post #15
- Forum: Tech Discussion
-
Dome lamp ground short circuit questions.
also it may be the smallest amount of ground coming through put a regular bulb in and see if it comes on when its not supposed to! these trucks wernt built for leds mine does it to kind of a nice glow! id agree with headlight switch! but will keep the original till she quits- 87scotty
- Post #16
- Forum: Electrical & Audio
-
What have you done to your square lately??
damn id kill for 11 im closer to 7 highway -
Some Big Block help please.
check out my 468 think ive got everything posted on there nice flat tq hp curves 500hpish 500ftlbs ush- 87scotty
- Post #2
- Forum: Engine & Performance
-
Carb or Fuel delivery problem?
i would say bad gas as well havnt had it in a few years but.you know when you get it- 87scotty
- Post #14
- Forum: Carb Fuel Systems
-
-
Help! Four Link bushings falling apart.
dont have that bolt to tight do ya?- 87scotty
- Post #2
- Forum: Lowered & Street Systems
-
Would 12 volts on a 6 volt system kill your ignition system if its not converted?
think most the fergussens and old fords at least the ones ive worked on were pos ground didmt have them flopped did ya- 87scotty
- Post #18
- Forum: Other Vehicles
-
I made it home anyway.
yea i get that alot just have to read slow and add it in where you see fit. did younread the dumb sh** i do you think i know where to put a comma,- 87scotty
- Post #50
- Forum: Other Vehicles
-
Do we have a show us your shop thread?
been pondering building a garage to store toys and cars shops getting over run -
Do we have a show us your shop thread?
it used to.be half dirt floor no lights walls or ceiling lived here two years its coming along -
Do we have a show us your shop thread?
since sold the stang window units keep it under 80 and no hummidity got a buddy coming to put the central ac unit in my backup furnace this fall hes a hvac guy pics up used units -
Transfer Case Crossmembers & Skid Plates
i also am in need of that strut rod anyone got 1 or know where to get it- 87scotty
- Post #38
- Forum: Transfer Case
-
Fender emblems.
im not sure ive ever had my fenders off but why is it difficult? ive taken off plenty of fenders on newer rides never gave me much of a fight? -
