Recent content by Soundmound
-
Newbie from France
Welcome from Central Washington! Cool truck brother.- Soundmound
- Post #26
- Forum: Introduction
-
-
Truck Size
I'm a fan of the 99-07 interiors and think they are probably the height of GM comfort. New trucks all have super thin seats compared to the previous generations. My '05 CCSB is super comfy/spacious. It has just enough of the creature comforts without all the extra complications of some newer...- Soundmound
- Post #15
- Forum: Other Vehicles
-
-
Tina King Chevy/GMC seatbelts
Assuming your plastics are good it's a teardown, clean, dye, reassemble process. My webbing was good so it was cleaned and dyed. Mechanical parts were cleaned and lubed. Plastics cleaned and dyed. Polished buckles and NOS buttons. She did have to trim one one the seat buckle covers to clean it...- Soundmound
- Post #19
- Forum: Interior
-
Tina King Chevy/GMC seatbelts
Fit and finish is not at all the same on new. If you want the factory look you have to restore.- Soundmound
- Post #16
- Forum: Interior
-
New Guy from Washington State
Welcome from Central Washington!- Soundmound
- Post #3
- Forum: Introduction
-
New guy from North California
Welcome from Central Washington!- Soundmound
- Post #11
- Forum: Introduction
-
-
Tina King Chevy/GMC seatbelts
She did mine. Great work all around.- Soundmound
- Post #14
- Forum: Interior
-
-
New member Lancaster Ca
Welcome from Central Washington! Great backstory on a real nice rig!!- Soundmound
- Post #10
- Forum: Introduction
-
new here, just relotated to GA
Welcome from Central Washington!- Soundmound
- Post #12
- Forum: Introduction
-
What have you done to your square lately??
This past weekend I fit the "bad" dash and installed all the AC ductwork. Put the glove box in, installed the seat and all the restored belts. Trimmed an awful lot to get the dash in and still need to pull it and remove some foam to level it out/fit the sides better and get the new bezel to seat...- Soundmound
- Post #20,187
- Forum: Garage
-
What have you done to your square lately??
This past weekend I fit the "bad" dash and installed all the AC ductwork. Put the glove box in, installed the seat and all the restored belts. Trimmed an awful lot to get the dash in and still need to pull it and remove some foam to level it out/fit the sides better and get the new bezel to seat...- Soundmound
- Post #20,186
- Forum: Garage
