Sgt Gus's latest activity
-
Sgt Gus replied to the thread 2 vs 3 v- groove power steering pulley.Lithium grease and made it happen with some 5/8" hose. Gonna loose my sh*t over a power steering pump. :Stupid Me: -
Sgt Gus replied to the thread 2 vs 3 v- groove power steering pulley.Damn, Lares pump reservoir tube diameter is 5/8"! Both old and new reservoir are 3/4"! WTF. What now?
-
Sgt Gus reacted to legopnuematic's post in the thread 2 vs 3 v- groove power steering pulley with
Like.
Either should be ok, something with Molybdenum Disulfide would be best. Be sure the pulley bore is clean and clear of any paint or... -
Sgt Gus replied to the thread 2 vs 3 v- groove power steering pulley.Should I put a little anti-seize on the shaft before I put the pully on, or lithium greese?
-
-
Sgt Gus reacted to Bill USN-1's post in the thread 1987 454 TBI stalls at idle after a short time with Like.
Here's my reply to you msg on binderplanet.com ____________________________________ Best to post in the injection forum then PM...
-
Sgt Gus reacted to AuroraGirl's post in the thread 2 vs 3 v- groove power steering pulley with Like.
depending on engine and setup, the extra ps pump pulley slot powered some compressors (larger groove) or SMOG pumps (small groove)
-
Sgt Gus replied to the thread 2 vs 3 v- groove power steering pulley.@legopnuematic. Depot didnt have one, but next time I'm near da Lowes. :Caffeine:
-
Sgt Gus replied to the thread 2 vs 3 v- groove power steering pulley.Also figured out all the bolts are metric. M10x1.5, 20-25mm. Went to depot (while thinking about legomatic saying get a Irwin measuring...
-
One stubborn bolt can mess up a lot....and drive one to the edge off insanity.
-
Sgt Gus reacted to Turbo4whl's post in the thread Project is stalled. Cannot solve brake problem with Like.
So the next step is back at the proportioning valve. There are 2 types, after you remove the rubber cap on the end of the valve you will...
-
Sgt Gus reacted to Ricko1966's post in the thread Project is stalled. Cannot solve brake problem with Like.
Did you adjust the brake booster pushrod properly? Not the rod from the pedal to the master,the one in the booster that pushes on the...
-
Sgt Gus reacted to Turbo4whl's post in the thread Project is stalled. Cannot solve brake problem with Like.
If the rear brakes shoes are not adjusted out to the drums, then you will have trouble bleeding the rear cylinders. Remember the (self)...
-
I did a part number search at Rockauto and with both numbers the same pumps come up...
-
Sgt Gus reacted to Ajax19's post in the thread What have you done to your square lately?? with Like.
Also got more 5/8" hardware to upgrade the 1/2" on the truck, old vs New brackets, another hitch receiver I'm going to add below the...
-
Roger 15. I didn't feel the need for a 60. https://marine-performance-parts.com/gmtbiperformance.aspx
