animal's latest activity
-
And done. So much for getting this done before the snow/ice hits tomorrow. Guess I'm driving the C10 home tonight and staying put for... -
So I tried to button up the rear axle for the final time last night. Went to remove the cross-pin aaaannndddd poop... I had read...
-
With your press woes, some extreme pressure grease goes a long way on making press fits smooth, mitigates galling, etc. something like...
-
So last night I decided to shimmy the carrier over to the pass side a touch more to tighten up my backlash. Remember spec is .006-.010...
-
animal replied to the thread Howdy- 1st Post.:welcome:
-
So now it's time to remove bearings. This is the tool Spencer (@legopnuematic ) suggested I pick up and I'm so glad he did. This is so...
-
Driver's side race had not fallen out yet so it came with the adjuster Pass side race had fallen out earlier just by me setting...
-
Couldn't hold everything and take a picture but using a straight edge got me much more reliable measurements than off the case openings...
-
Maybe cuz the front diff isn't always spinning so the bearings dry out and it's rough on them the first few seconds of engagement? Or...
-
Backside of the vent Everything looks pretty clean inside considering the schmutz we saw earlier Then took out the 15mm bolts...
Latest posts
-
-
-
-
-
Update: The surging stopped....took me by surprise- Latest: backwoodsman