animal's latest activity
-
This is all that actuates the front axle. A little shift fork and collar. Pass side/long side adjuster Driver's side/short... -
Didn't get any shots mid-pull cuz it was sketchy AF trying to get that thing to balance on the transmission jack while it also rolls off...
-
So then I popped out the drain plug to let it start draining while I pulled the CV axle bolts out Fluid looked pretty good but there...
-
So then yesterday I came up to the shop to work on the front diff since my new bearings from QP didn't show up Saturday like I'd hoped...
-
Ok, so I made a couple adjustments last Friday and forgot to post them. Took .005" off the pinion shim and shifted the carrier to the...
-
animal replied to the thread New to GMSB from Oregon.:welcome:
-
On my lunch break I fixed my carrier bearing (I just flipped the pass side over upside down, the driver's side was ok), made a soupier...
-
animal replied to the thread Hello from Arlee,Montana.:welcome:
-
So finally, I could check backlash and run a pattern. I have the factory .036” shim on the pinion and both factory shims on the sides of...
-
So what I finally found was, the GM bearings were quite a bit bigger than the Koyo’s that came in the kit, so they weren’t going down in...
-
Threw the pinion and carrier in. Ran into a snag that no matter what shim combo I ran, once I tightened the caps, everything locked down...
-
Made some more progress last night and today. We lost power at work about 4:15 yesterday, so I took that opportunity to throw in the new...
-
animal replied to the thread Hello from Munich, Germany 87' R10.:welcome:
-
Got all my stuff in from Quick Performance right before Xmas and the last few things for the engine reseal. 4.88s/Yukon Duragrip. Went...
-
animal replied to the thread Introductions! New member from Florida.:welcome:
