Vent window gasket placement?

[Josh Barnett]

On 91 suburban doors do the vent window gaskets sit on the outside or are they tucked in? Didn't pay attention when pulled out.

You must be registered for see images attach

You must be registered for see images attach

 

[chengny]

On 91 suburban doors do the vent window gaskets sit on the outside or are they tucked in? Didn't pay attention when pulled out.

The lower leg and the hypotenuse wrap around both side of the frame and are visible from inside and outside. The vertical leg - the one where the lock handle is mounted - is kind of tucked into the frame on the outside and is not visible from in the cab. So, from what I can see, you have it right.

 

[Submariner592]

Very nice job, as said before looks correct. I tried mine 2 times (failed huge) and finally sent it to a guy in CO to do it for me. ($ ouch)

You must be registered for see images attach

 

[MikeB]

Very tough job. Took me many hours and lots of sweat to get the fit right. Used both ends of plastic putty knives and lots of soapy water to coax the rubber into the frame. My fingers were sore when I was done!

 

[foamypirate]

They should tuck into the door frame like so:

You must be registered for see images attach

 

[Josh Barnett]

They should tuck into the door frame like so:

You must be registered for see images attach

thank you, I think I got them right...

You must be registered for see images attach

You must be registered for see images attach

 

[Oldrider]

I have a dumb question, are you doing this with the vent installed on the door or removing the vent window?

 

[Josh Barnett]

I have a dumb question, are you doing this with the vent installed on the door or removing the vent window?

The vent is inside the door but not fully seated yet, then I pushed the gasket in as I worked the vent back into place.