-
-
TDoes anyone here have experience with purchasing good quality “bolt in” replacement hinges that fit well to OEM? My top and bottom hinge...
-
TNot that I'm aware of. I've seen some people online say they just used thick 3M adhesive but don't have any direct experience. I've...
-
TI’m planning to drill the holes for the side molding and then use the 3m thick two way adhesive for the long trim piece for cab rear.
-
THey all, The rear cab of my truck has no molding that wraps around the rear of the cab. I very much like the look of this however the...
-
TI like the 40 series with an H pipe. Had this on my '72 Nova and it sounded great on a simple mild small block. Current set up on my...
-
TAlso, there's more to the cats/no cats thing. Yes, running without them will make the exhaust louder. Especially when compared to the...
-
TThat's why I was asking what type of muffler you have now. Everyone has their own opinion on what's loud. If it's a welded type muffler...
-
TTruckCo replied to the thread Best Flowmaster.Bucket im only saying generic cus there is absolutely no marking at all on the muffler , not even a P/N or S/N. Its also 2.5". Right now...
-
TWhat type of muffler is the current "generic" muffler? Crimped case? Welded case? Knowing what you might have now will make it easier to...
-
TRun them 40 series and getcha an H pipe.
-
TI like it, a lot depends on the length of the tail pipes. A better version would include a lumpy cam
-
TTruckCo replied to the thread Best Flowmaster.do they have a nice loud idle?
-
TBeen running 40’s forever. To avoid drone run em straight back & tip down. They bark & growl, but don’t drone.
-
TThe Flowmaster “50” series used to be their quiet ones.. not sure about now.
-
TI don't run cats. I'd say a super 44 is pretty barky. Not bad though. Probably more than what you want. I would recommend a crossover...
-
-
Loading…
-
Loading…
