Sm465 knocking while in reverse

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Turbo4whl

Supporting Member
Supporting Member
Joined
Oct 30, 2019
Posts
3,126
Reaction score
7,257
Location
Downingtown, PA
First Name
Wayne
Truck Year
1974
Truck Model
Jimmy
Engine Size
350
I checked it again this morning. It's not as bad an angle as I thought .....

I do think the problem is in the trans.

I have to ask, did you check the oil level in the trans?
 

Jarrett Melvin

Full Access Member
Joined
Oct 17, 2020
Posts
93
Reaction score
42
Location
Newfoundland
First Name
Jarrett
Truck Year
1983
Truck Model
C20
Engine Size
350
I've went back and double checked the u joints and drive shaft. All good. There is a little slop in the pinion and some play in and out on the output shaft.

Tightened by u bolts as well. Still making making same noise. Reverse only, high,l or low rpm, clutch in or out
 

trukman1

Full Access Member
Joined
Apr 20, 2018
Posts
340
Reaction score
138
Location
USA
First Name
Gary
Truck Year
1988
Truck Model
K5 Blazer
Engine Size
5.7 L (350)
This probably was a once in a lifetime thing but my automatic did that only in reverse. Turned out the bellhousing bolts weren't tightened all the way. Worth a check.
 

Dan Brown

Full Access Member
Joined
Nov 4, 2017
Posts
64
Reaction score
29
Location
Katy, Texas
First Name
Dan
Truck Year
1974
Truck Model
K10
Engine Size
355 (.030 over 350)
I put a Muncie M20 in a 55 Chevy years ago and had a clicking in first gear. Turned out to be a chipped tooth in first gear. Just some food for thought.

Too, if your new one piece drive shaft is longer than 72 inches it's too long. I assume your truck is a long wheel base. If so, that's why the two piece shaft with center bearing support.

More food for thought. I worked for a Military Truck Manufacturer, again, years ago, and we had lots of problems with the deuce and a half rear drive shaft. Kept throwing them off. Turned out to be the weenie U bolt type U joints. After going to what's called 'Full Round' joints, problem solved. That being said I was in charge of the program, along with Rockwell, the manufacture of the shafts, to solve other problems. I did lots of research and learned a hell of a lot about drive shafts and U joints, which is why I know that 72 inches is crowding it. Too, with too long a drive shaft, you can hit what's called 'critical speed', which causes the drive shaft to look like a banana while tuning and eventually fly off. Had that happen a bunch on these trucks.

Keeping the U joints in phase, as the pictures show, and the shafts well balanced, is also very important.

Good luck.
 

Forum statistics

Threads
44,173
Posts
950,842
Members
36,288
Latest member
brentjo
Top