Grit dog
Full Access Member
- Joined
- May 18, 2020
- Posts
- 7,071
- Reaction score
- 12,409
- Location
- Auburn, Washington
- First Name
- Todd
- Truck Year
- 1986, 1977
- Truck Model
- K20, C10
- Engine Size
- 454, 350
If the OP comes back, fitment basically has zero to do with rim diameter and everything to do with backspacing, and tire size and to a lesser extent rim width (in combination with bs/ offset.
As the OP was more fixated on the brand and diameter, the 2 least important parts of the fitment equation, spending some time understanding offset and tire size is needed.
Not too tough if you draw a picture of the backspacings and write down the desired tire sizes in common measurements.
Then just go measure what’s on it and add/subtract from those dimensions to check clearance of your theoretical new sizes and offsets.
And just to give the boomers something to comment on, 20s on a C10 look pimp! And I don’t gaf if someone doesn’t like them. Pretty sure I could pick apart some of your choices in vehicular attire….lol.
As the OP was more fixated on the brand and diameter, the 2 least important parts of the fitment equation, spending some time understanding offset and tire size is needed.
Not too tough if you draw a picture of the backspacings and write down the desired tire sizes in common measurements.
Then just go measure what’s on it and add/subtract from those dimensions to check clearance of your theoretical new sizes and offsets.
And just to give the boomers something to comment on, 20s on a C10 look pimp! And I don’t gaf if someone doesn’t like them. Pretty sure I could pick apart some of your choices in vehicular attire….lol.
