Installing a New Exhaust System Including Headers

[Normmus]

I am installing a new dual exhaust system on my stock '77 K10 to replace the swiss cheese straight pipe. I am also installing long tube headers. I have the passenger side header bolted in and the collector flange is touching the driveshaft. Any tips on bending it to clear? I am reluctant to heat it much because the header is ceramic coated.

 

[3 Ton]

Going the wrong way. Single with a Magnaflow torque master will deliver more low end for off roading than a sheet hotrod set up. I had what you are building. I ripped it all off and have low end power up the wah zoo.

 

[SquareRoot]

I agree 100% with Fred. And, I'll add the Hooker Cast manifolds are even better. But, I doubt the OP is going to change course at this point if he's spent big bucks on Ceramic Coated Long Tubers.