Guess The Tool

[Keith Seymore]

You must be registered for see images attach

Placing the tool in the teeth of the flywheel and wedging it against the transmission dowel pin keeps the crankshaft in an assembled engine from rotating, while torqueing the harmonic balancer bolt or using the aforementioned compressed air in the cylinder.

K

 

[Keith Seymore]

Here's a couple easy ones:

You must be registered for see images attach

You must be registered for see images attach

 

[bucket]

Here's a couple easy ones:

You must be registered for see images attach

You must be registered for see images attach

Slide hammer and seal driver?

 

[crpntr78]

Here's a couple easy ones:

You must be registered for see images attach

You must be registered for see images attach

2nd one a clutch aligning tool?

 

[SDJunkMan]

Here's a couple easy ones

Damm Keith, your " easy ones" aren't so easy, but keep them coming, we're learning!

I am guessing that the slide hammer has a specific purpose?

 

[Honky Kong jr]

Here's a couple easy ones:

You must be registered for see images attach

You must be registered for see images attach

Pipe bomb?!?!?

 

[Blue Ox]

I'm guessing driver for freeze plugs or the welch plug for the camshaft.

 

[yevgenievich]

This is interesting one, not for a vehicle.

You must be registered for see images attach

Edit:
Small radiation detector for inspecting the back of an eye.

 

[Honky Kong jr]

I’m gonna guess Ted @78c10bigten oh wait that tool looks useful. Lol

 

[Blue Ox]

I think my dentist has one of those.

 

[Keith Seymore]

Slide hammer and seal driver?

Pretty close -

I am guessing that the slide hammer has a specific purpose?

Yes - it is used for pulling the rear axle carrier out of the housing on a Pontiac rear. Attach the countersunk hole to one of the ring gear bolts and slide away!

(Dad always called it a "whopper knocker").

The second one is for installing the pinion bearing on the gear.

K

 

[Keith Seymore]

Were getting down to the tough ones now. This one I suspect you will never get. (Just because there is not much to it, and its geometry really doesn't give much of a clue as to its specific purpose) -

You must be registered for see images attach

 

[Derrick]

Were getting down to the tough ones now. This one I suspect you will never get. (Just because there is not much to it, and its geometry really doesn't give much of a clue as to its specific purpose) -

You must be registered for see images attach

a small piece of round stock. lol

 

[78C10BigTen]

Since everyone wants an easy one....

You must be registered for see images attach

 

[Keith Seymore]

a small piece of round stock. lol

That's what it started out as...

(lol)

Actually - I think it was a big socket head cap screw that has been turned down to a specific diameter.

K