Crew Cab Driveline(s) After Gear Vendors Installation

[AKguy]

I have planned a Gear Vendors OD installation on my 1980/81 K30 454/TH400/NP205/3.73’s Crew since I began the project. I sense the geometry change for the forward section of the rear driveline will change to an intolerable degree. I have also read here that at least one poster eliminated the bearing and had a single driveline made. Anyone experience this situation with a Crew? Thanks.

 

[MarineOne]

A single aluminum shafy is what your going to want. Call or go to dennysdriveshaft.com those fellas make top tier driveline and can answer any questions you'll have. I have them in all my cars

 

[AKguy]

HMX-1?

 

[Bennyt]

I'm planning on adding a GV unit as well and I was told same as above. 1 piece shaft. I am putting it behind a 700r4 in my 90 cc

 

[Big Ray]

Just an FYI, i saw a GV unit for a NP203 on fleabay last night.