Condenser Replaced - a few pics

[Powerhouse Ranch]

Anyone have a link to a trustworthy A/C condensor nowadays for a late 80s square? I had got one that was "perfect fit" for my rig, but clearly wasn't. even with moving the mounts the lines hit into the rad support regardless; they're supposed to stick out and do not. Not sure the exact number but it is a Spectre condenser, and so far it's ****. Any help would be appreciated!

You must be registered for see images attach

 

[rsbad454]

Anyone have a link to a trustworthy A/C condensor nowadays for a late 80s square? I had got one that was "perfect fit" for my rig, but clearly wasn't. even with moving the mounts the lines hit into the rad support regardless; they're supposed to stick out and do not. Not sure the exact number but it is a Spectre condenser, and so far it's ****. Any help would be appreciated!

You must be registered for see images attach

Did you figure anything out? I ordered one of these too and it's way smaller to fit normally in core support.

 

[Snoots]

is the condenser parallel flow design?
Found they have a retrofit unit for older trucks:
part number:636420
http://www.oreillyauto.com/site/c/detail/OMR0/73642.oap?ck=Search_636420_-1_710&keyword=636420+

dead link

 

[Bextreme04]

dead link

Not surprising... since the post was from 10 years ago and they no longer make the part. This is the only similar one I seem to be able to find... good ratings, but straight from chi-na
https://www.amazon.com/dp/B003R377NU/

 

[yevgenievich]

UAC one looks similar. Other UAC condensers that I have tried holding so far. 636420 unit mentioned a while back has been discontinued.

 

[dd1990]

Did you figure anything out? I ordered one of these too and it's way smaller to fit normally in core support.

You have move all the condenser bushings inward, there extra slots to slot in, top driver side had to drill a hole abolt the original bushing, I also cut some of the rubber bushing in the middle

 

[Powerhouse Ranch]

Did you figure anything out? I ordered one of these too and it's way smaller to fit normally in core support.

no i never figured anything out. in fact, i'd decided to remove every last component of the AC system in that truck and swapped it to a heater only setup. Kinda how i like my Squares nowadays