Advice on Transmission Fluid Change for 1980 C10

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Grit dog

Full Access Member
Joined
May 18, 2020
Posts
6,928
Reaction score
12,142
Location
Auburn, Washington
First Name
Todd
Truck Year
1986, 1977
Truck Model
K20, C10
Engine Size
454, 350
If it’s operating fine then absolutely change it. Sounds like a good truck if it’s never been apart and still is truckin.

If you don’t pump it out the cooler lines to get the majority of old out, I’d get a pan with a drain plug and change it about 4x depending how much comes out. That’ll effectively replace about 90% of it.
 

Grit dog

Full Access Member
Joined
May 18, 2020
Posts
6,928
Reaction score
12,142
Location
Auburn, Washington
First Name
Todd
Truck Year
1986, 1977
Truck Model
K20, C10
Engine Size
454, 350
If it’s operating fine then absolutely change it. Sounds like a good truck if it’s never been apart and still is truckin.

If you don’t pump it out the cooler lines to get the majority of old out, I’d get a pan with a drain plug and change it about 4x depending how much comes out. That’ll effectively replace about 90% of it.
Unless you’re lucky and there’s a drain plug in the tq converter but it’s not likely.
 

Turbo4whl

Supporting Member
Supporting Member
Joined
Oct 30, 2019
Posts
3,118
Reaction score
7,229
Location
Downingtown, PA
First Name
Wayne
Truck Year
1974
Truck Model
Jimmy
Engine Size
350
Unless you’re lucky and there’s a drain plug in the tq converter but it’s not likely.
The only factory torque converter that had a drain plug in them were old Fords. (I've only ever seviced trucks, don't know about cars.) Aftermarket converters may have a plug, but the OP stated he believed the trans was not apart.
 

Forum statistics

Threads
44,057
Posts
948,517
Members
36,124
Latest member
dabsRus420
Top