350 sbc build help

[454400208]

Hi im wanting to build a 350 for my 76 shortbed, it has a 4 speed and a 208 transfer with 1/2 ton axles and 3.73 gears. I want the most power i can and i am on a limited budget since im a teenager. Which aluminum heads, cam, and intake would be the best combination? The engine has dish top pistons and im going to use these. This is a daily and toy to play around in

 

[Driver4r]

Budget..
That can be interpreted differently.
To most, budget would be 882's refreshened.
But if you want the best bang for the buck, get you some vortecs. you will need a vortec carb intake to match.
As for the rest, a nice .030 355 with flat tops and a 268/282 cam would be pretty peppy, especially if you like low range.


I just seen, your reusing the dished pistons? Are these stock bore? I there no ring ridge?

If your running dished pistons, DEFFINETLY go vortecs, and you can even get them shaved down to 60cc(mine are, and I smoothed the bowls). And run a .015 steel shim to keep your compression up, considering that they are probly in the hole about .0450.