2 piece drivelines

[Bigred3plus3]

So when I bought my crewcab it didn't have a motor tranny t case or drivelines in it. So swapped a LS th400 np205 into it. My question is should the front half of the 2 piece driveline be on the exact angle as the motor and tranny them angle down to the rear axle or should it start angling down from the t case down to the rear axle? It is lifted 6 inches.

Sent from my SM-G970U using Tapatalk

 

[AuroraGirl]

to my understanding, you need to have a relatively low angle the whole way... like, the angle should be consistent and

You must be registered for see images attach

2-3 degrees at most, .5 degree at least, ideally smack in the middle to account for spring compression and subsequent desprunging(who does words, pfft)

 

[Buickspec6231]

I don't know off the top of my head, but I can measure mine for you on Monday when I am back out at the shop.

 

[Bigred3plus3]

Ok cool thanks

Sent from my SM-G970U using Tapatalk