Search results

  1. M

    oil pressure switch

    Need help figuring out how to remove wire plug from old oil pressure switch 1987 k1o
  2. M

    heater command (loose lever)

    Need help with climate control cable? My original cable broke ordered one from LMC. Can anyone help me with how to connect and adjust cable to right length? Right now it is connected, it slides fairly easy when moved to hot, but when I slide it back to cold it gets stuck. Don’t want to force it...
  3. M

    Tick at idle

    Thanks! what are the steps to pull distributor out? To install that oil pump shaft guide. Thanks
  4. M

    Tick at idle

    Hello, this very interesting! what does it take to replace this piece? Thanks!!
  5. M

    Running rich

    Looking for help/sugestions for my 1987 4x4 1/2 ton is either running rich and or my idle is fast. It has 350 TBI all stock 700r transmission. Thanks
  6. M

    tailgate fix

    need help with a tailgate problem. I found a tailgate off a 1978 1/2 ton chevy. While removing it from the truck one of the nuts that is welded inside snapped off. The nut that snapped off is located where the bracket bolts on to insert the tailgate in the trunnion. Now the bolt that goes into...
  7. M

    Chevy lean

    Hello, need help! My 1987 4x4 1/2 ton Chevy suburban has a lean to it. When you are looking at it, the drivers side leans ( lower than passenger side). Any suggestions on what to check and look for. Thanks Mike
  8. M

    id rear end

    thank you for the information. Does any body have any pics and or information on how to change front u joints, and i would like to change to manual hubs? thanks
  9. M

    id rear end

    Thanks to all Well that is good news! That it is normal and that I have a open differental. As far as engaging the 4 wheel drive. Can I shift on the fly? If so how fast should can I be going? I know in low it is just for creeping low speed. Any help would be greatly appreciated.
  10. M

    id rear end

    need help! I posted a thread about my 1987 1/2 ton 4x4. When shifted in 4 hi and or 4 lo it rolls rough. Well I had a friend watch my rear tires when I was in 4 wheel drive. He noticed that it looked like one of the wheels wanted to turn quicker. He advised me to jack up the rearend, place it in...
  11. M

    10 Bolt Rear Axle Oil Change w/ Factory Limited Slip

    Numbers on back differential Can any body tell me what these numbers mean. They are from my 1987 Chevy 1/2 ton 4x4, 350, 5.7 tbi. The numbers are off my rear differential: GM1, H126, 14055251. These are the only numbers found on it! Thanks for the help.
  12. M

    4 wheel help

    Thanks for a the replys! Tires and pressure all the same, stock not lifted. The truck goes into 4 hi and 4 lo. just fine. When in 4 wheel mode you can feel it engage. How should I trouble shoot this? Starting from easy to extreme! Thanks
  13. M

    4 wheel help

    thanks for the reply! When I put the truck in 4 wheel hi or lo it drives but feels like something is out of round. No noise, vibration or shimmy.
  14. M

    4 wheel help

    Hello fellow SQ Body's, my 1987 chevy 1/2 ton rolls really rough when placed in 4 wheel hi and low. Any thoughts on what might cause this? Any suggestions would be geatly appreciated!
  15. M

    Is it possible, 87 w/factory 350TBI & 700r4

    LMC catologes have how to interpet your vin number. I believe it will tell you all the information you are looking for. I have a 1987 1/2 ton 4x4 with 350/Tbi, 700r4 transmission.
  16. M

    Truck Dies when put in reverse.

    my truck is fixed!! bad ecm and prom . installed a use ecm and prom truck runs great.
  17. M

    Truck Dies when put in reverse.

    thanks for the response No strange noises! The truck will move it does not die. A friend says it sounds electrical like a short.
  18. M

    Truck Dies when put in reverse.

    to be continued Thank you for those replies! yes it only dies in reverse! Yes it has been checked for vacum leak(s). I took it to a very good shop, the owner has just been tinkering with on his free time. He has also had his onther mechanics look at it . So far nothing, the latest tthinking...
  19. M

    Truck Dies when put in reverse.

    need help. 1987 Chevy 1/2 ton 4 wheel drive, 350 tbi, 700r tranmission. dies when put in reverse.
  20. M

    troubled?

    Need help? my 1987 Chevy Silverado K10 4X4, 350 tbi, 700r stalls/dies when put in reverse. Any suggestions would be helpful. Thanks

Latest posts

Forum statistics

Threads
44,205
Posts
951,658
Members
36,343
Latest member
PC Hot Rods
Top