Search results

  1. TotalyHucked

    1981-82 Metal Lower Tailgate Mldg

    You're right, but I think these may well have just been tape. Though it's so hard to find any info on this setup at all though, I can't say for sure.
  2. TotalyHucked

    Tires Plus says my Dually tires are too heavy to balance.

    I've been told this a couple times in the past. First time (I was like 19 and this was my first truck and first set of mud tires, so I didn't know any better) was stock '05 Silverado 17" wheels with 295/70/17 mud tires (roughly 33s) that weighed 77lbs each. I let them put the balance beads in...
  3. TotalyHucked

    Heat box swap

    Not something I've ever encountered. What don't you like about your original unit? It may just need a revamp, the heat in my '85 will run you out
  4. TotalyHucked

    1981-82 Metal Lower Tailgate Mldg

    From my vast research on the subject, it looks like there were some plastic clips that were 3M'd to the tailgate that the molding then attached to
  5. TotalyHucked

    Squarebody to GMT400 Chassis Swap

    Yep, quite a bit. GMT400 is when the fuel tank went inside the frame rails, so they're at least wider by the width of a fuel tank on each side.
  6. TotalyHucked

    Show your daily driver

    The big white Fiat is officially gone! Met the dude at his bank yesterday, got a certified check and cancelled registration today. Now to find a nice NBS crewcab Z71
  7. TotalyHucked

    Squarebody to GMT400 Chassis Swap

    I haven't seen that one done with an OBS, only with NBS trucks. There's nothing "simple" about it, it's a TON of work. You'll have to fab up mounts both on the cab and frame side, you'll also have to figure out how to integrate the OBS harness since those trucks are IFS with actuators and...
  8. TotalyHucked

    diesel to LS wiring harness?

    Hit up BP Harness first off. I know they can make custom harnesses and they're just about the best in the biz for LS Swap harnesses. If they can't, American Autowire would get my vote. Get a harness for the 305/350 version of your truck and then hit up BP for the conversion harness to add
  9. TotalyHucked

    Dash Brake light comes on after a couple minutes of driving

    Is your ebrake hooked up? When I had cut my cables to pull the axle out for a rebuild, I never hooked it all back up, just zip tied them to the frame rails. Because of that, the ebrake pedal would droop just ever so slightly sometimes and cause that light to come on
  10. TotalyHucked

    ‘87 454 R20 eye watering exhaust w/ windows down

    Yep, the way aero works, the air tumbles behind the truck and brings exhaust into the cabin. Gotta kick the exhaust out the sides behind the tires so it won't do that so bad. I had a K5 Blazer with exhaust like that. Truck ran great, motor was in tip-top shape but it would kill you from the...
  11. TotalyHucked

    L76 Rebuild

    Well, depends on how rowdy you want and whether or not you want to put a loose converter in or not. Not saying you do or don't cuz I don't know but if you don't have a good understanding of camshaft design and how they work, I'd suggest calling or emailing either (or both) company so they can...
  12. TotalyHucked

    L76 Rebuild

    What's the plans for the truck? Cruiser, drag truck, autoX, highway flyer, all of the above? I've used both BTR and TSP and had good experiences with both
  13. TotalyHucked

    Rear End Recommendation for 87 with an LS

    Quick Performance should be your first call. Great guys over there that can set you up with what you need. I bought everything to upgrade and rebuild my stock 10-bolt from them if you want to go that route. Or they offer 9" assemblies for these trucks as well. With the super deep 1st gear in...
  14. TotalyHucked

    Old77’s Oldest Kid’s 1992 S10 Blazer thread

    That's interesting, I haven't seen that either. 'Course, it's been 15+ years since I've worked on an S truck
  15. TotalyHucked

    Desperately look for this trim piece

    I didn't even know this was a thing :hmm: I'm not aware of anyone repopping those, or at least I've never run across them (clearly, if I didn't even know they existed lol). I can tell ya we (AMD) wouldn't repop it since clearly it's a fairly rare/not super desirable/not often searched for piece.
  16. TotalyHucked

    What have you done to your square lately??

    Drove it for the first time in like 2 weeks, to work cuz it’s been at home waiting for my Ram to sell.
  17. TotalyHucked

    Narrowing a Square Fleetside Bed

    Found his Instagram, there's a ton more pictures there. poisedhipster is his handle https://www.instagram.com/poisedhipster/?fbclid=IwZXh0bgNhZW0CMTAAAR1BIVGZMp10sW9z7ZfBtDNzbScj3TbiYbXKLdZJ4j1D3OhSKr15N8wfYfo_aem_d2b2q77TpsNGVdXjYv8b-w
  18. TotalyHucked

    new glass options

    Depends on what your truck has, green and clear were options when new. Green was referred to as “tinted glass”. Take a white piece of paper and hold it on one side while you look through. That’ll tell you what you need.
  19. TotalyHucked

    Narrowing a Square Fleetside Bed

    Like this one? Seen it at Dino’s twice now, it’s pretty good https://cktruckmag.com/white-knight/
  20. TotalyHucked

    Show your daily driver

    Got a verbal/handshake agreement to sell it today :banana-mario:
  21. TotalyHucked

    Southeastern Truck Nationals - Lebanon, TN July 12 & 13, 2024

    Man, as good as SETN is, Fall Revival is 10 times better. Close to double the turnout, much better location (awesome fairgrounds area with an old 1800s mini-town and lots of old steam equipment around) with about half of the grounds being shaded, not to mention later in the year so not near as...
  22. TotalyHucked

    Starter problems after doing 5 speed swap

    Gotcha. I haven't dealt with them other than talking to them at shows. Seem like good guys, but I do know it's a small-ish operation
  23. TotalyHucked

    Starter problems after doing 5 speed swap

    Have you contacted American Powertrain yet to see what they say? I wouldn't do anything further until I got their opinion since it's their kit.
  24. TotalyHucked

    Front end assembly hardware

    Unfortunately we're (AMD) still working on the hardware. We're working with Auveco to get some whole kits done as well as sub-kits but we're still probably a year or more out on that one.
  25. TotalyHucked

    '73 Chevelle SS Wagon (local find)

    Right? Poor thing, I love the '73 SS cars with the inset tail lights.

Latest posts

Forum statistics

Threads
44,157
Posts
950,592
Members
36,271
Latest member
jstewart7501
Top