Show your daily driver

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

bucket

bucket

Super Moderator
Staff member
Super Moderator
Joined
Aug 3, 2010
Posts
30,446
Reaction score
28,352
Location
Usually not in Ohio
First Name
Andy
Truck Year
'77, '78, '79, '84, '88
Truck Model
K5 thru K30
Engine Size
350-454
gmbellew said:
I Krown my 1990 burb every fall. $150 per year is cheap if it keeps it from rusting.
Click to expand...

But do you drive it day in and day out, all year?

I cleaned it all the time and powerwashed all the nooks and crannies on the underside too. After every single time off-roading it, I spent an hour or so getting all the mud and stuff blasted off the underside of it. It had a power steering, oil and transmission leak and I never fixed them simply because they did a good job of coating the underside. The salt and brine still got into the seams and violated my poor Suburban.
 
Catbox

Catbox

Full Access Member
Joined
Jul 12, 2018
Posts
4,452
Reaction score
16,684
Location
Just Outside of Portland Oregon
First Name
Peter
Truck Year
1979
Truck Model
C20 Silverado Camper Special
Engine Size
461
bucket said:
The sad part is where I live, you can't drive a Burb year-round for 21 years and still have much body remaining.

Our '88 was downright solid when we bought it in early '06. 10 years later, it really wasn't roadworthy. In '16 we bought a very nice '00 Burb and now, it's nearly as rusted as our '88.
Click to expand...
You would hate me if I went out there and took a photo of the underside of it...
The factory paint still looks good under there with zero signs of rust all covered in road grime.

These are from a few years ago when we did the rear end again.
This is when I munched the Detroit Tru Trac that is behind that junkyard diff cover.
You must be registered for see images attach


Fresh rebuild with some Home Depot black rebuild in a can sprayed on it and the junkyard 3/4 ton leaf springs we put back under it.
Notice those clean wheel wells lacking in rust.
You must be registered for see images attach


The Flowmaster I put under it shortly after I purchased the Sub took 18 years to rust out the welds.
And it has been replaced with some other Flowmaster variants, only to go back to the original 40 series style as it was the right sound.
You must be registered for see images attach


I almost never wash the underside of the Burb either.
 
Last edited:
78C10BigTen

78C10BigTen

Full Access Member
Joined
Apr 12, 2017
Posts
15,950
Reaction score
25,350
Location
pennsylvannia
First Name
Ted
Truck Year
1978
Truck Model
C10 BIG TEN
Engine Size
350
Sh
Catbox said:
You would hate me if I went out there and took a photo of the underside of it...
The factory paint still looks good under there with zero signs of rust all covered in road grime.

These are from a few years ago when we did the rear end again.
This is when I munched the Detroit Tru Trac that is behind that junkyard diff cover.
You must be registered for see images attach


Fresh rebuild with some Home Depot black rebuild in a can sprayed on it and the 3/4 ton leaf springs we put back under it.
Notice those clean wheel wells lacking in rust.
You must be registered for see images attach


The Flowmaster I put under it shortly after I purchased the Sub took 18 years to rust out the welds.
And it has been replaced with some other Flowmaster variants, only to go back to the original 40 series style as it was the right sound.
You must be registered for see images attach
Click to expand...
Shame, mine looks like it came off the titanic lol
 
bucket

bucket

Super Moderator
Staff member
Super Moderator
Joined
Aug 3, 2010
Posts
30,446
Reaction score
28,352
Location
Usually not in Ohio
First Name
Andy
Truck Year
'77, '78, '79, '84, '88
Truck Model
K5 thru K30
Engine Size
350-454
Catbox said:
You would hate me if I went out there and took a photo of the underside of it...
The factory paint still looks good under there with zero signs of rust all covered in road grime.

These are from a few years ago when we did the rear end again.
This is when I munched the Detroit Tru Trac that is behind that junkyard diff cover.
You must be registered for see images attach


Fresh rebuild with some Home Depot black rebuild in a can sprayed on it and the 3/4 ton leaf springs we put back under it.
Notice those clean wheel wells lacking in rust.
You must be registered for see images attach


The Flowmaster I put under it shortly after I purchased the Sub took 18 years to rust out the welds.
And it has been replaced with some other Flowmaster variants, only to go back to the original 40 series style as it was the right sound.
You must be registered for see images attach
Click to expand...

Yeah, I'm definitely jealous of the "good" areas for vehicles.

The '00 Express that I brought up from south central VA looks that good underneath. Incredibly nice. Now I don't drive it everyday because I'm out of town a bunch, but I can just about guarantee that 5 years from now, it will look like every other rotted van in Ohio.
 
bluex

bluex

Full Access Member
Joined
May 9, 2013
Posts
1,974
Reaction score
2,585
Location
Spartanburg SC
First Name
Paul
Truck Year
1978
Truck Model
C15
Engine Size
350
CountKrunk said:
This is what i was balancing with my recent 2000 4runner purchase. New enough to cruise reliably and in comfort. Old enough that it's easy to work on.
Click to expand...

That was the idea with this buick. It was just neglected a bit by POs. I about have it sorted now I think. It still occasionally does some weird stuff but I mainly just use it to get to work so who cares lol.

The cooling system was full of sludge. This was last piece, honestly it was probably fine with a flush but with as cheap as it was I figured why not. I won't do another one though :lol:
 
G

gmbellew

Full Access Member
Joined
May 27, 2018
Posts
1,214
Reaction score
1,283
Location
Kansas city
First Name
glen
Truck Year
1990
Truck Model
suburban 1500
Engine Size
350
bucket said:
But do you drive it day in and day out, all year?

I cleaned it all the time and powerwashed all the nooks and crannies on the underside too. After every single time off-roading it, I spent an hour or so getting all the mud and stuff blasted off the underside of it. It had a power steering, oil and transmission leak and I never fixed them simply because they did a good job of coating the underside. The salt and brine still got into the seams and violated my poor Suburban.
Click to expand...

yes, for the last 6+ yrs...at about 15k miles per year. i give it a good wash/wax spring and fall, even though some previous paint job clear is failing badly. i don't let mud or road salt sit on it too long without a wash. and I visit Krown each fall, usually late October or early November. they spray the underside and inside all the body panels and doors with a coat of their oil.

no signs of rust yet, and I've done it each fall since ive owned it. but it might be a different story in 5 or 10 years, who knows. but I hope it's enough to keep the rust at bay...
 
TotalyHucked

TotalyHucked

Full Access Member
Joined
Feb 24, 2020
Posts
3,671
Reaction score
11,863
Location
Auburn, Georgia
First Name
Zach
Truck Year
1985
Truck Model
Sierra 1500
Engine Size
5.3
CountKrunk said:
This is what i was balancing with my recent 2000 4runner purchase. New enough to cruise reliably and in comfort. Old enough that it's easy to work on.
Click to expand...
Was talking to my buddies about this the other day, I think all mid-90s to late-2000s cars/trucks/everything are just going to continue to go up in demand for exactly that reason. More and more people are getting fed up with newer cars, if they're at all mechanically inclined, I know lots of people going back to older stuff. My GF had to drive my '05 Z71 yesterday so I could take her '21 F150 to work to pick something up that she'll be transporting this weekend, when I got home she told me again how much she really likes that truck. I told her we could prob sell her F150 off for enough to pay off the loan and get her a nicer one than mine, she's considering it.
 
TotalyHucked

TotalyHucked

Full Access Member
Joined
Feb 24, 2020
Posts
3,671
Reaction score
11,863
Location
Auburn, Georgia
First Name
Zach
Truck Year
1985
Truck Model
Sierra 1500
Engine Size
5.3
Started working on bringing the paint around on this old girl as well as getting rid of the pinstripe

xc_hide_links_from_guests_guests_error_hide_media

You must be registered for see images attach


You must be registered for see images attach
 
Last edited:
Grit dog

Grit dog

Full Access Member
Joined
May 18, 2020
Posts
6,976
Reaction score
12,228
Location
Auburn, Washington
First Name
Todd
Truck Year
1986, 1977
Truck Model
K20, C10
Engine Size
454, 350
Catbox said:
You would hate me if I went out there and took a photo of the underside of it...
The factory paint still looks good under there with zero signs of rust all covered in road grime.

These are from a few years ago when we did the rear end again.
This is when I munched the Detroit Tru Trac that is behind that junkyard diff cover.
You must be registered for see images attach


Fresh rebuild with some Home Depot black rebuild in a can sprayed on it and the junkyard 3/4 ton leaf springs we put back under it.
Notice those clean wheel wells lacking in rust.
You must be registered for see images attach


The Flowmaster I put under it shortly after I purchased the Sub took 18 years to rust out the welds.
And it has been replaced with some other Flowmaster variants, only to go back to the original 40 series style as it was the right sound.
You must be registered for see images attach


I almost never wash the underside of the Burb either.
Click to expand...
Dude, you’re just rubbing salt in the (lol salt hahaha) wounds of everyone in the rust belt! It’s cruel for car guys. You’re from here I believe. Don’t understand the struggle!
Hahaha I grew up in Shitcago. In 1990 I had a 75 C20 and an 80 Blazer. Both of which looked like @AuroraGirl truck except 35 years ago.
Feel bad for them fellers….
You must be registered for see images attach
PS the flowmasters from 1998 on the blue truck just gave up the ghost 2 years ago. They were of legal drinking age for 3 years before they fell apart. It was tragic (exhaust pipe is still ok)!
 
Rumbledawg

Rumbledawg

Full Access Member
Joined
Jul 15, 2021
Posts
269
Reaction score
1,021
Location
the back 40
First Name
Dan
Truck Year
1985
Truck Model
K30 crewcab
Engine Size
454
still on the hunt for a tahoe, so i'm reduced to driving this... thing.....sad face...
You must be registered for see images attach
You must be registered for see images attach

pretty tough keeping 6 vehicles insured, so my crewcab is parked for the winter as is my kid's firebird, we want to do the bodywork anyways and get it painted this winter. i gave my son my rcsb so i'm using the wifey's XUV and it barely rates as a soft roader, too low, too long.
my buddy's mom however has a pretty sweet '05 ZR2 blaze for sale. me and my son are going to look at it tomorrow or thursday. if i buy it i'm going to take back my rcsb with the 6 and drop the tbi 350 from my stepper into it and the kid can take the ZR2
120 000 miles, mint shape, buddy's mom bought it from the orig owner yrs ago and did i mention it's mint?
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
 
You must log in or register to reply here.

Similar threads

TotalyHucked
Huck's daily - 2005 Z71 crewcab
2 3 4
Replies
58
Views
2K
TotalyHucked
TotalyHucked
JamesSam
Looking At Buying 1997 Cheyenne C1500 As Daily Driver Feedback Please
2 3 4
Replies
58
Views
4K
Rumbledawg
Rumbledawg
T
daily driving/work truck use
Replies
12
Views
1K
DoubleDingo
DoubleDingo
yellow eyed Andi
Andi from Hannover/Germany with my 1985 C10 Stepside named "Daily-Blue1"
2
Replies
19
Views
927
Sgt Gus
Sgt Gus
Stormhawk
New Member in Eastern Montana
2 3
Replies
40
Views
2K
mxer147
mxer147

Latest posts

Forum statistics

Threads
44,173
Posts
950,865
Members
36,288
Latest member
brentjo
Top