Ricko1966's latest activity
-
RRicko1966 replied to the thread Rebuilding rear axle DIY?.Yep, keep all your shims where they came from replace all the bearings and the seal.Use the crush sleeve eliminator because the crush...
-
RI'm assuming I can do it with the axle still on the truck correct?
-
RRicko1966 replied to the thread Computerized carb.So you have a new carb from national? What engine did you buy the carb for? I'm pretty sure the ECM on that truckn8s going to need to...
-
ROnly need a couple of "specialty" tools. If you can follow directions, you can do it yourself. If you could rebuild a motor, you can...
-
RRicko1966 replied to the thread Rebuilding rear axle DIY?.Yours will be easy,no special tools. I put the info on another post,look what I posted to edelbrock. Even if you have to go completely...
-
RRicko1966 replied to the thread Rebuilding rear axle DIY?.Yours should be stupid easy,sounds like you've lost a pinion bearing buy both pinion bearings and pinion seal,buy both differential...
-
R1985- automatics do not have a neutral safety switch. Went to mechanical interlock on steering column/steering wheel
-
RRicko1966 replied to the thread HIT THE IGN. KEY AND NOTHING.I doubt he has a neutral safety switch,didn't read his year and don't remember the break off the top of my head. If the new switch...
-
RAnd if/when I do this again I am most likely going to use your method.
-
RRicko1966 replied to the thread Toe adjustment 1987 V10.A lot of what I was posting was for others following the thread. So if they try this they will be successful.
-
RRicko1966 replied to the thread Toe adjustment 1987 V10.One more thing to add,To use a board as a toe plate isnt as simple as just placing a board across the tires. Here is why and what you...
-
R:console:
-
RSNORT I'd forgotten this was a three speed manual conversion question.
-
RScott, you need to tag Nick @NickTransmissions for him to see your ?????
