peats's latest activity
-
Ppeats replied to the thread New K1500 Project Owner.I don't run spares in any trucks. You can find a 12v compressor with sealant for about $50. That will give you about a 50/50 chance of...
-
PI experienced this twice - once on a large GM 4 door car and once on a Jeep with a 2.5L GM engine. In both cases, the diaphram on the...
-
PThou shalt not put them Ford parts into Chevies. ;D The 1990 7.3 uses a mechanical fuel pump to feed the injector pump. Using the...
-
P^^^^ this. You'll spend 1/3 on fuel as you will if you big block swap. And a 6.2 will pull anything you put behind it.
-
PHowdy from Ohio! How long have you had it? If you drive it a bit more, you may find that you actually like the 6.2, along with it's...
-
PAbout 6 inches ;)
-
PSage advice here. Despite my previous reply. I didn’t think of the trouble code being an EFI truck. To be fair, the last one I disabled...
-
PThanks! That is the same user name they used on another forum to try and scam someone. I banned them, as well as another member that...
-
Ppeats reacted to SquareRoot's post in the thread What is this 2 prong Plug above the oil filter? with
Like.
Plug it into an extension cord. Report back. -
PScam. Look at top left, watermark was removed Original:
-
Ppeats reacted to DoubleDingo's post in the thread How to switch from a DRW to a SRW in a 1981 K30 / 350 engine / 3 speed manual / 4x4 with Like.
Hence, leave it alone and enjoy it as GM created it
-
Ppeats reacted to bucket's post in the thread If you live in PA and see this truck it’s mine! with Like.
Pittsburgh and Philadelphia are pretty darn far away from each other. So you just narrowed it down to either close to @89Suburban, or...
-
Ppeats replied to the thread Replacement Panels - All Created Equal - Yes or No?.I've been using LMC for over 20 years. I never had a problem. I have seen videos on YouTube where most of the original GM dies were sold...
-
PGood exhaust makes power down low too.
-
PYou should seriously consider some Hookers at this point ;) 10X better than the OEM style. Better in every way.
Latest posts
-
-
-
-
Center/carrier bearing orientation - 76 C20 suburban
- Latest: HotWheelsBurban
-
