Recent content by kalger

  1. kalger

    A/C Question

    Thanks for that. Do you have a write up on your conversion plan/path? I might look into that as it would be nice to have A/C on occasion.
  2. kalger

    A/C Question

    I'm working on removing my SBC 350 from my 1975 GMC C1500. It has factory A/C that doesn't work. Not sure what the issue is, probably the compressor. Anyway, what are the options to remove all the A/C bits and pieces (not sure how charged the system is still) and then put everything back...
  3. kalger

    TH350 Removal

    In a perfect world, yes. Based on where the truck stopped running well, this wasn't a viable option.
  4. kalger

    TH350 Removal

    Thanks everyone. I found the bolts and was able to remove them without too much difficulty once they were found. I'm very much looking forward to getting everything cleaned and degreased before putting everything back together. Thanks again!
  5. kalger

    TH350 Removal

    AMAZING! Thanks all.
  6. kalger

    TH350 Removal

    I'm attempting to get my TH350 transmission out of my 1975 GMC C1500 with a 350 sbc. I can find two bolts that connect the transmission to the engine block. How many should I be looking for and any tips or tricks to a) find/see/feel the other ones, and b) get them out? Add to the "fun" that the...
  7. kalger

    Engine Rebuild Kit Recommendations

    Thanks all for the comments and suggestions. I will reach out to a local engine shop and see the price for all of the machine work. I might just go with an engine replacement to save some headaches.
  8. kalger

    Engine Rebuild Kit Recommendations

    I'm looking for a recommendation for an engine rebuild kit for my 1975 GMC 1/2 ton PU with the 5.7 350 engine. Any information would be very much appreciated. Thanks.
  9. kalger

    New guy here, Thanks for having me

    Welcome!
  10. kalger

    Old, retired guy new to this group.

    Welcome!
  11. kalger

    First Time Square Body Owner

    Welcome from Oregon. Nice looking truck. They are a lot of fun!
  12. kalger

    New to the forum with alot of questions.

    Thank you for your service and welcome to the forum.
  13. kalger

    New Member Here

    @Mr Clean, thanks for that. That's the direction I think I'm going to head, but it's good to hear that it's an "easy fix." Any recommendations on a 110 Welder? (Flame wars start now, I suppose.)
  14. kalger

    New Member Here

    Driver's rear panel Driver's front fender Passenger side door Passenger side rear panel Here's the rest of the visible rusted-out spots, @Grit dog. Overall not horrible, but still needs some attention. Not sure if that front fender is worth saving with a patch or just replacing it all.
  15. kalger

    New Member Here

    @Grit dog All of the documentation I have and the VIN indicate it's a 1/2 ton. That's what I'm leaning toward for the bed. I'll need to start searching for a replacement and either learn how to weld or find someone local to do that work. If you have any leads for a replacement bed here in the...
See more

Latest posts

Forum statistics

Threads
45,317
Posts
980,627
Members
38,345
Latest member
skarletjunkyard
Top