gmbellew's latest activity
-
Ggmbellew replied to the thread 87 tbi 350 popping at idle and running rich.the sometimes lack of power and sometimes fine makes me think about an intake manifold vacuum leak. also check to make sure the EGR...
-
Ggmbellew replied to the thread 87 tbi 350 popping at idle and running rich.a timing light works well for this. the strobe effect helps. and while the timing light is out, I'd disconnect the EST and check base...
-
Ggmbellew replied to the thread One more electrical plug identification.pretty sure green wire single connector is the temp sensor for the gauge between cylinders 1 and 3.
-
Ggmbellew replied to the thread washer pump not working.I have a similar situation. my washer won't work when it is below about 50deg in the cab. works great after cab warms up and all spring...
-
Ggmbellew reacted to Goldie Driver's post in the thread Planning my Suburban build - Advice wanted with
Like.
I'd agree that it looks good as is. I'd try to sell it as is and then find more of a beater to modify fenders, etc. -
Ggmbellew replied to the thread How to "Un-Lift" my suburban.350/700r4/4.10 would be pretty good with 32-33in tires. I have the same in my burb but with 3.73. I wouldn't mind a little more gearing...
-
Ggmbellew replied to the thread 1987 454 TBI stalls at idle after a short time.I think some of the 454s idled in open loop as a matter of the stock PROM. So open loop idle might not be anything to worry about.
-
Ggmbellew replied to the thread 1987 454 TBI stalls at idle after a short time.I've had intermittent short to ground issues on ECMB and ECMI circuits kill the engine. usually it blows a fuse. but sometimes I think...
-
Ggmbellew replied to the thread 1987 454 TBI stalls at idle after a short time.this is a direct link- http://aldlcable.com/aldl.asp also you can check out...
-
Ggmbellew replied to the thread What have you done to your square lately??.not sure what the issue is, but TBI > Carb. diagnose whatever the issue is and fix the TBI
-
Ggmbellew replied to the thread 86 1/2 ton gears needed for 33” with new 383.there is a rare 4.30ish something, but it isn't commonly available. with 32-33in tires, that would just about put it like stock tires...
-
Ggmbellew replied to the thread Dakota Digital RTX gauge cluster.maybe it is intentionally off center and at an angle to allow better viewing of the lower left gauge spot from the drivers point of view.
-
Ggmbellew replied to the thread 86 1/2 ton gears needed for 33” with new 383.I have 350tbi/4L60/3.73 in my burb with "33's" that actually tape out around 32 inches. it is adequate enough that I won't likely...
-
Ggmbellew replied to the thread LED Issues.I plan to stick with incandescent bulbs for brakes/blinkers because of these sorts of issues. I just don't see the huge upside with LED...
-
Ggmbellew replied to the thread 1987 V3500 Engine update.out of curiosity, why aren't you sticking with the TBI?
Latest posts
-
-
-
-
-
Update: The surging stopped....took me by surprise- Latest: backwoodsman