fast 99's latest activity
-
The return setup would be preferred with today’s lousy gas. The 3 port pumps have a tiny orifice in the return fitting, basically a... -
fast 99 replied to the thread Lifter tick?.If style with a hose on it remove the end piece. Any exhaust leak will be quite noticeable as air passes by the end of the open hose.
-
fast 99 replied to the thread Lifter tick?.If you suspect exhaust leak, get a stethoscope. They are very inexpensive at HF. Bad fuel pumps or worn push rods can sometimes sound...
-
fast 99 replied to the thread Running unrebuilt original heads? Might need lead substitute above 8500gvw.Convertors were on lighter duty trucks. Probably the same head but lead would kill cats. In the past I have seen several early heads...
-
fast 99 reacted to 75gmck25's post in the thread TRC Actuator and Air Conditioning Solenoid Question with
Like.
My ‘75 has no solenoid to increase the idle with A/C on (factory A/C and no evidence it ever had a solenoid) and it does not cause any... -
fast 99 replied to the thread No crank. No power at all 1885gmc 2500.above first, follow 12v downstream until voltage is lost. Be sure to check grounds and inspect for dark, loose or corroded connections.
-
fast 99 reacted to YakkoWarner's post in the thread No crank. No power at all 1885gmc 2500 with Like.
If you have no power anywhere, I'd start with the basics - put a meter on your battery and make sure you have power (yes I know you ran...
-
If you had both boxes apart and reassembled,you set both of those clearances on assembly,the endplay gets set by how tight the end...
-
fast 99 replied to the thread '77 C10 350/TH350 ignition problem.At 6:43 red greased area on top may be holding it. Part of tilt assembly. Should be able to release with the tilt lever. Have the tilt...
-
fast 99 replied to the thread '77 C10 350/TH350 ignition problem.If tilt assembly is loose at all now is a good time to tighten the lower bolts.
-
fast 99 replied to the thread 87 v10 transmission and ac compressor swaps.Inspect the orifice tube/filter. Lots of metal better flush it and refill with correct quantity of oil.
-
fast 99 replied to the thread 87 v10 transmission and ac compressor swaps.is the compressor pully seized or the compressor itself? If it had an internal failure there will be metal tossed throughout the system...
-
fast 99 replied to the thread 87 tbi 350 popping at idle and running rich.Didn't go back and read all the replies has anyone suggested a possible exhaust leak?
-
fast 99 replied to the thread 73 Blazer 350 spark plug stuck.If the porcelain can be blown out as suggested I would try to drill and tap whats left provided there is access. Use grease on the bit...
-
fast 99 replied to the thread Engine mount, old or new?.I usually replaced the mounts. Many times upper bracket attached to the block will be laying hard against the cross member or frame...
Latest posts
-
-
-
-
Center/carrier bearing orientation - 76 C20 suburban
- Latest: HotWheelsBurban
-
