fast 99's latest activity
-
fast 99 reacted to Ricko1966's post in the thread 87 tbi 350 popping at idle and running rich with
Like.
First thing I'd do is a power balance test. If you are running equally on all cylinders,I'd test fuel pressure,map sensor,coolant... -
fast 99 replied to the thread Paint Source for 1983 K20.A semi retired friend still does higher end painting on one or 2 cars a year. Automobile completes he orders 2 gallons of base. Usually...
-
-
fast 99 replied to the thread Paint Source for 1983 K20.And buy much more than the project will need if this will be a longer duration paint job. Mix colors change, matching down the road may...
-
fast 99 replied to the thread rock auto discount code for 10/24 to 11/8/24.I usually received a discount code in an e mail a few weeks after placing an order. Good for 4-6 weeks. edit, My discounts have always...
-
fast 99 reacted to Goldie Driver's post in the thread 1978 k35 proportioning valve question with Like.
I would leave it alone. The OE are better built and my experiment with an aftermarket PV2 unit, I believe, gave no better results and...
-
fast 99 reacted to Ricko1966's post in the thread Project is stalled. Cannot solve brake problem with Like.
Did you adjust the brake booster pushrod properly? Not the rod from the pedal to the master,the one in the booster that pushes on the...
-
fast 99 replied to the thread Project is stalled. Cannot solve brake problem.When bench bleeding a master do not bottom out the piston. It is possible to cut one or more cups doing so. Are the caliper bleed screws...
-
fast 99 replied to the thread LMC Dash Pad Supplier.Has anyone bought an 81 up pad recently? One I purchased [a Dashes Direct part] did not fit the cluster bezel area upper left corner...
-
-
Platigage won't tell you if the bearings are standard .010 etc. It will tell you if clearances are correct. When you resize a rod or...
-
fast 99 replied to the thread 1966 Ford Galaxie 500.I could certainly be mistaken but can't remember seeing a Cleveland or Windsor based 351 in anything older than 69. Have seen small...
-
fast 99 replied to the thread 1966 Ford Galaxie 500.probably a 352? Another one of those never will happen would be a Coyote V8 conversion in a 1957 Ford Ranchwagon with a newer chassis...
-
fast 99 replied to the thread Quadrajet Spacers.My interpretation of a hard hot soak start occurs only after a relatively short period of time. In the area of 15 minutes. Every one of...
-
If it is a 3 port pump there is no check valve in the return line,they will drain back through the return line, if you have a windowed...
-
fast 99 replied to the thread AC Condenser - Should I use New Or Original..Agree, except today original rubber parts are 40-50 years old. Would be advisable to replace with barrier hose and all new o-rings...
-
fast 99 replied to the thread 1966 Ford Galaxie 500.Always liked the 66 design. Owning a 7 Liter has always been in back of my mind.
