fast 99's latest activity
-
fast 99 replied to the thread Replacing stock clock with small tachometer in 83 C20.I installed a mechanical temp gauge through the bezel and cut out the cluster housing as needed for clearance. Hole in bezel was made... -
What transmission is in the truck? If it is 700r4 make sure the geometry on the TV cable is correct before you even drive around the...
-
Those new tank straps can be a real pain, I had to use a ratchet strap to get mine to conform so the nuts could be started. I would try...
-
fast 99 reacted to Bloodhound1981's post in the thread Thinking about a new smaller steering wheel, comfort grip or forever sharp? with
Like.
Same here, Actually mine is out of my 1978 Camaro. I bought it when I was 16 for $400 back in 1994. I junked that POS a year later, but... -
fast 99 replied to the thread Head versus manifold coolant temps.Had a mechanical sender in the head on a 350. Averaged 10-15 degrees hotter than the stat. In other words with a 190 stat head was...
-
fast 99 replied to the thread Inside the steering column, what is the steering "rack?".Use that phone in your pocket to take pictures during disassembly. Especially of rack area.
-
fast 99 replied to the thread Thinking about a new smaller steering wheel, comfort grip or forever sharp?.Had one from a 70's Camaro fit perfect no modifications. Saved the stock wheel.
-
-
Idle mixture/ idle circuit isn't going to keep it from starting. It's not even on the idle circuit on a cold start,it's on the fast idle...
-
fast 99 replied to the thread Quadrajet rebuild problems.Couple of alternate methods to clean out idle passages. Using carb cleaner spray into mixture screw holes and or air pressure. Another...
-
fast 99 replied to the thread Hydro Boost.Agree parts are poor quality. However, last time I looked into rebuilding a PS pump internal parts were beyond expensive.
-
fast 99 replied to the thread K20 upgrades. EDELBROCK AVS II. Why so negative ?.Agree q jets are becoming harder and more expensive to rebuild. Last q jet I did took 2 cores to make 1 carb. Choke housing was bent...
-
fast 99 replied to the thread 1978 chevy 350 issue.Cam and lifters is in your future. When fixed, use oil for flat tappet cams.
-
fast 99 replied to the thread 1978 chevy 350 flexplate issue.possible, haven't seen that problem before but given the quality of parts today nothing surprises me.
-
fast 99 replied to the thread O2 sensor question.With the proper release tool wires can be removed from connector and re-installed. It's a common repair procedure for bad connections.
