fast 99's latest activity
-
fast 99 replied to the thread 1978 chevy 350 flexplate issue.Run out after being bolted up is a problem, before doesn't matter. -
Take the rocker arms, push rods and lifters out and inspect the cam lobes to see if they're wiped. You can also inspect the lifters...
-
fast 99 replied to the thread Choke Issues.Think an 83 would have both a primary and secondary pull off. 3/16" gap on the choke plate is a good starting point for pull off...
-
That could possibly hide a bad choke pull off. The pull offs job is to pull the choke plate open as soon as there is vacuum.
-
Make sure non of your linkage is binding. Check that the choke pull off is connected and working. Make sure the diaphragm on the pull...
-
fast 99 replied to the thread 1978 chevy 350 issue.above or lifters that have bleed off or worn out internally. Sometimes takes while to get all the air out of lifters even with engine...
-
fast 99 reacted to DoubleDingo's post in the thread Should the windshield wipers park on a 1974? with
Like.
Yeah they should park -
fast 99 replied to the thread Help figuring out correct front inner wheel seal.Normal, seen hundreds like that. Actually sometimes seals may rub slightly on the shield if dirty on that area.
-
fast 99 replied to the thread Hydro Boost.no
-
fast 99 replied to the thread Hydro Boost.PS pump cavitation can cause air to be introduced into the fluid. When vehicle is shut off the air expands, pushes fluid out of the...
-
fast 99 replied to the thread Knocking noise in D and R after high revs.blue locktite
-
fast 99 replied to the thread Knocking noise in D and R after high revs.High revs? how high? Winding an unloaded motor excessively can be very detrimental to longevity.
-
Should be good as long as the shims for the carrier spacing go back how they came out.
-
fast 99 replied to the thread 1974 c10 didn’t start-fuel problem?.Haven't had any luck with local parts stores. Mostly only use them for fluids. I primarily buy from Rock auto for normal replacement...
-
fast 99 replied to the thread Quadrajet Spacers.Hot soak issues have been around since the EPA started messing with fuel. My SB's do start a bit hard after hot soak. Not horrible but...
