fast 99's latest activity
-
fast 99 replied to the thread 1987 454 TBI stalls at idle after a short time.FYI, TBI primarily uses MAP for fuel trim. O2 sensor only effects trim after reaching operating temp and usually will not stay hot... -
fast 99 reacted to Vbb199's post in the thread 1987 454 TBI stalls at idle after a short time with
Like.
If you had a means to scan the obd1 interface, you could check manifold pressure.... but since those all seem to be gone from the... -
fast 99 replied to the thread Bench Seat Foam Fitment Options.Like me others have had very bad experiences with USA1, never again.
-
fast 99 replied to the thread Fuel Valve Replaced.First thing that comes to mind is dirt. Check fuel filter, pump pressure and volume.
-
fast 99 replied to the thread 208 Milky fluid.Rather common, especially with front diffs that haven't been used enough. Condensation and no heat to burn water off. Water will usually...
-
fast 99 replied to the thread 1987 suburban tbi 350 overheating..Doubtful, in 30 years of repair work only seen a handful of bad impellers. Those were in heavily rusted systems, impellers were rotted...
-
fast 99 replied to the thread Cylinders washed need help.............and all it takes is one backfire to blow a PV. If it's a Holley PV is bad/leaking, to those who dislike Q jets joking. I...
-
The way a power valve works is at low vacuum conditions( the farther you are in the throttle the lower your vacuum readings) so when you...
-
fast 99 replied to the thread Cylinders washed need help.Go back to basics. Spark, fuel, timing by TDC and rotor position. If all checks out try a new set of plugs. Also check for 12V on choke...
-
fast 99 replied to the thread Cylinders washed need help.check fuel level/float/ idle mixture, running. Should be fuel just below opening, side of bowl. Accelerator pump only works during...
-
fast 99 replied to the thread Cylinders washed need help.It is possible to wash rings out of a new engine. Way rich, although probably no damage has been done yet need to fix whatever is...
-
fast 99 replied to the thread Trans braces not installed when motor went in, can I fix with a little welding/fab work?.Install them, support for tranny case, very necessary for longevity.
-
fast 99 replied to the thread Trans braces not installed when motor went in, can I fix with a little welding/fab work?.Short ones appear to be rear ac bracket or alt as someone else pointed out. They should go to intake studded bolts.
-
fast 99 reacted to nvrenuf's post in the thread Trans braces not installed when motor went in, can I fix with a little welding/fab work? with Like.
Jack the motor up and slip the brackets in like they are supposed to be. Those short bars look like a/c compressor braces, there might...
-
fast 99 reacted to TotalyHucked's post in the thread Trans braces not installed when motor went in, can I fix with a little welding/fab work? with Like.
I would lift/jack the motor up and install the way they were intended
