Drauka99's latest activity
-
Drauka99 replied to the thread LS freeze plug issue.If I guessed I’d say rust pitting from a slow leak for a long time before it got bad enough to be discovered. -
Drauka99 replied to the thread What have you done to your square lately??.Took the truck to town on Sunday for a shake down run. Gas tank filled and ran it home. Took care of a few more small details and...
-
-
Drauka99 replied to the thread LS freeze plug issue.know some who when reinstalling a freeze plug in situations like that us a thin application of rtv on the rim of the new freeze plug to...
-
Drauka99 replied to the thread What new tools have you got lately?.Worked on a job years ago where they had to run a new large water service for the fire suppression system on the building. The water...
-
Drauka99 replied to the thread 04 LM7 into 87 K5.The VSS in the trans (before the Tcase) will read the same speed regardless of the T-case being in high or low. The ECM(PCM) uses VSS...
-
Drauka99 replied to the thread New Process A833 4speed w/ OD MY6 MM7.Only thing I've seen mentioned is the bushing for the input (or output) shaft wear out and the case being aluminum they get wore badly...
-
Drauka99 replied to the thread What new tools have you got lately?.Don't know if this counts but my workshop build gets stated Wednesday. Hired a group to put up a roof. 40'x60', of that ill have a...
-
Drauka99 replied to the thread What have you done to your square lately??.I'm getting close to my project being back on the road. Tag acquired. I have 90% of the interior back in it and the exterior is...
-
Drauka99 replied to the thread What radiator are you using for the 5.3.I am running the stock heavy duty radiator that came with my Vortec/LS. You can cut out the lower radiator support out of the donor...
-
-
Drauka99 replied to the thread New Process A833 4speed w/ OD MY6 MM7.Thanks, mine is the round tube. It's the lesser desirable aluminum case version of the trans, I'll replace it with a NV3500 i have on...
-
Drauka99 reacted to Keith Seymore's post in the thread New Process A833 4speed w/ OD MY6 MM7 with
Like.
Yes. Insert shim stock on both sides of the shifter and it should pull right out... -
Drauka99 replied to the thread New Process A833 4speed w/ OD MY6 MM7.So is it correct that to remove the shift arm on this trans there are two retaining springs (one on each side, I assume passenger side...
-
Drauka99 replied to the thread Rear Sag on One Side.Its a single tank on the driver side. We threw a level at it parked on a level floor and its a bit over an inch without the driver...
-
So my truck sat in a fence row for 20 years before I got it. Its an 81. The rear of the truck on the driver side has about an inch of...
-
Drauka99 replied to the thread What have you done to your square lately??.I got the last of the headlight pigtails replaced and all the headlights and bezels back in place. Mounted the tucked rear bumper...
