Craig Nedrow's latest activity
-
Craig Nedrow reacted to Danielle0297's post in the thread Journey of a Gen VI 454 Rebuild. Reluctor Ring Issue. Need help! with
Like.
I've got a 1977 Chevrolet C30 that I'm putting a motor in. My original motor that came in truck was an 82 however when starting to... -
Craig Nedrow reacted to peats's post in the thread New to engine swaps, looking for help with an LS3 swap into my 79 k20 with Like.
What is a LS going to do for you that the 400 can't do? People swap 350's and collect 400"s I heard that once here. I've had a few 400's...
-
Craig Nedrow reacted to Chepe's post in the thread New to engine swaps, looking for help with an LS3 swap into my 79 k20 with Like.
I put a junkyard 5.3/4L60e into my '83 K10. Bolted a reluctor ring onto the output shaft where it goes through the 4WD adapter, in...
-
Craig Nedrow reacted to Hunter79764's post in the thread New to engine swaps, looking for help with an LS3 swap into my 79 k20 with Like.
There's tons of info out there, but in general, you need to address a few items. From the fact that you are asking the question, I'm...
-
Call comp cam,call blueprint and let's see if we can get @Mark Jones to weigh in on this if you are wanting to tone it down I'm...
-
:welcome: Guys on here have been working on them awhile and willing to help. Love the site and community!
-
Craig Nedrow replied to the thread BBC 489 build.It's Thursday and had a little shop time. Block is clean now, and was able to install the crank and get it all torqued down. Got the...
-
-
Craig Nedrow replied to the thread BBC 489 build.My mufflers are Holly Aero-Chamber, Headers are Flow Master 1 7/8 for a chevelle. It is what I orignally ran on the mostly stock 454...
-
-
Had the same thing when I did the dingleball rebuild on the slant six in my Dart, put new cam bearings and and go to drop the cam in...
-
Craig Nedrow replied to the thread BBC 489 build.Tomorrow is town day, and visit Mom, so probably not any shop time. The machine shop should have checked this, BUTTT, I am the one doing...
-
-
Craig Nedrow replied to the thread BBC 489 build.Some done today. Back cam bearing was too tight, unfortunately I had installed the crank. Fortunately the crank spun so nice , but I...
-
-
Craig Nedrow reacted to 78C10BigTen's post in the thread Looking for Mickey Thompson rims with Like.
One of my all time fave wheels!
-
Craig Nedrow replied to the thread Post 454 rebuild and oil consumption.I run the thinnest oil I can, determined by mechanical clearances in your engine. I use Schaffer. Do not over fill the pan. I generally...
-
Craig Nedrow reacted to Ricko1966's post in the thread Post 454 rebuild and oil consumption with Like.
I built an engine once, bored,new pistons,rings,everything, it was all top notch and no machine work was skimped. Rings wouldn't seat...
-
Craig Nedrow reacted to Ricko1966's post in the thread Post 454 rebuild and oil consumption with Like.
I didn't want to start a big discussion about break in oils,because everyone has their own opinion. Mine is, I'd run Dino oil until the...
