Craig Nedrow's latest activity
-
Heavier oil probably won't change consumption but won't hurt either, Give it a try if you're so inclined. -
What was the piston ring gap
-
You don't think a quart in 500 miles is a bit excessive, even for a very fresh engine? I do agreed though, just continue to monitor the...
-
Craig Nedrow reacted to txaggie's post in the thread Post 454 rebuild and oil consumption with
Like.
Correct. Wagner Pcv fixed orfice settings on the driver side cover, monster breather on the passenger side. -
Craig Nedrow reacted to Ricko1966's post in the thread Post 454 rebuild and oil consumption with Like.
I wouldn't be worried at this point give the rings time to seat,keep monitoring it it should start to taper off. If you don't see...
-
Craig Nedrow reacted to txaggie's post in the thread Post 454 rebuild and oil consumption with Like.
Howdy all, We had our 454 pulled and rebuilt in the c20 suburban. We used king bearings throughout and converted to a hydraulic roller...
-
Craig Nedrow replied to the thread What A 500 + HP Peanut Port 454 Looks Like.Always good to see you Mark. What cc are the pistons, 20? Also what did your static compression ratio come out at? Are you running a...
-
Craig Nedrow reacted to Vbb199's post in the thread What A 500 + HP Peanut Port 454 Looks Like with Like.
So it appears like it ran with no alt, ps, accessories and an electric water pump, And you ran pop top pistons to squish the chamber...
-
Craig Nedrow reacted to Mark Jones's post in the thread What A 500 + HP Peanut Port 454 Looks Like with Like.
35 degrees total is where it was raced at.
-
Craig Nedrow reacted to Mark Jones's post in the thread What A 500 + HP Peanut Port 454 Looks Like with Like.
Bucket showed some interest in the peanut port BBC, here's some pictures and full story behind this 585 HP smooth idle 454 peanut port...
-
Craig Nedrow replied to the thread Looking for Mickey Thompson rims.I always ran US Mag Indy 101, they have 17X10, but I contacted them, and they were very responsive, and would put in any BC you want on...
-
-
I bought a set in that size when the III's were fresh to the public. I've been happy with them. The finish has actually held up way...
-
Yes, it's a 6 spade gang.
-
I will look into how to tell what is drawing with a volt meter. Believe that will be my next step thanks.
-
The battery was 8years old and I replaced that thinking it was the issue as well.
