Craig Nedrow's latest activity
-
My crimp connection on passenger side wasn't the best so I'm redoing it. I cleaned the GP relay studs for voltage in and out. Traced the... -
@Strick , believe me buddy I sat on that starter until the bolts literally actually came loose. And I had to go there and make sure the...
-
82 6.2 diesel, suburban k20 Diesels needs glow plugs to go (GPs). I did a fuel job, injectors, injector lines return lines etc...
-
Spray some WD-40 down that Detroit's throat...plenty of it. Give it a chaser of carb or brake cleaner as the GP's do their thing. It...
-
Craig Nedrow replied to the thread BBC 489 build.Surprisingly, no interference with crank so also a plus. Massive interference between the head and piston. Checked piston CH +1.280 so...
-
-
Craig Nedrow replied to the thread BBC 489 build.Deburr bearings on both sides, install crank with light oil, and spins freely, so no line bore needed. Installed piston and rod on #1...
-
-
Craig Nedrow replied to the thread BBC 489 build.Brought my 454 aka 489 home from the shop, it was later in the afternoon, so I did not get to much done. However I did set up my bore...
-
-
Craig Nedrow reacted to Ricko1966's post in the thread Knocking noise in D and R after high revs with
Like.
I wasn't going to go that in depth he knows he has an obvious problem,which needs fixed before he goes any further. I've done this and... -
Craig Nedrow reacted to PrairieDrifter's post in the thread Knocking noise in D and R after high revs with Like.
Not necessarily. Especially since it's not loaded in neutral and park. Cars are strange creatures. They can make any noise sometimes...
-
Craig Nedrow reacted to fast 99's post in the thread Knocking noise in D and R after high revs with Like.
High revs? how high? Winding an unloaded motor excessively can be very detrimental to longevity.
-
Craig Nedrow reacted to Ricko1966's post in the thread Knocking noise in D and R after high revs with Like.
You know it's wrong,fix it. Then see what happens.
-
Craig Nedrow reacted to Ricko1966's post in the thread Knocking noise in D and R after high revs with Like.
They should be tight together.
-
This is exactly what i was looking for sir! I am going to replace the switch first because it’s easier lol however now i know this might...
-
Craig Nedrow reacted to gmbellew's post in the thread 86 1/2 ton gears needed for 33” with new 383 with Like.
I have 350tbi/4L60/3.73 in my burb with "33's" that actually tape out around 32 inches. it is adequate enough that I won't likely...
-
Craig Nedrow reacted to labratm's post in the thread 86 1/2 ton gears needed for 33” with new 383 with Like.
I have a similar setup, 86 383 4x4 with 33's with a 4l60e. I went with 4.11's and it's pretty much perfect. You could probably go a...
