Craig Nedrow's latest activity
-
Craig Nedrow reacted to HotWheelsBurban's post in the thread Help figuring out correct front inner wheel seal with
Like.
Some companies make that seal like National does, with no lip. Other companies make it with a lip on the back side. I've used both on... -
Craig Nedrow reacted to fast 99's post in the thread Help figuring out correct front inner wheel seal with Like.
Normal, seen hundreds like that. Actually sometimes seals may rub slightly on the shield if dirty on that area.
-
Craig Nedrow reacted to Bullet Bob's post in the thread Help figuring out correct front inner wheel seal with Like.
Just to make sure I’m understanding correctly for anything the future. A seal with a smaller width can be used as long as it has the...
-
Craig Nedrow reacted to fast 99's post in the thread Help figuring out correct front inner wheel seal with Like.
Measure depth to inner bearing race or first lip in hub. If enough depth install it. Bearing seal design will vairy between...
-
Craig Nedrow reacted to Bullet Bob's post in the thread Help figuring out correct front inner wheel seal with Like.
Got the right seal from bumper to bumper by the office. Don’t know what the deal was at Oriley’s using the 46453 number. Guy looked up...
-
Many primers are porus,the metal will rust under the primer.
-
Craig Nedrow replied to the thread Replacement doors?.The worst part is you need to strip the existing stuff off first b-4 painting. Soooo paint remover, clean, dewax, epoxy primer, color...
-
If you are going with aftermarket doors,instead of used doors you will have to paint. They are coated enough to protect them in a...
-
Craig Nedrow replied to the thread Trying to identify this color of blue.this might help, #29 85: https://www.cjponyparts.com/resources/chevy-c10-paint-codes#1978
-
Welcome from Central NC. There are plenty of info threads here as well as folks that will share experience & knowledge. I did a...
-
Hi I am new here I actually have a 63 k10 with a 454 th400 on 86 k5 axles. I am here for the information Thank you
-
Craig Nedrow replied to the thread Replacement doors?.Bought mine from Brothers now holly, look good.
-
Craig Nedrow reacted to Ricko1966's post in the thread First real drive! Not tragic but not good. I think I need carb advice. with Like.
Put a plastic fuel filter in the end of the vapor line,it can still vent,but keeps dirt,bugs,etc out of it. If the throttle return...
-
Craig Nedrow reacted to Chris64's post in the thread First real drive! Not tragic but not good. I think I need carb advice. with Like.
My latest change. I didn't like the spring going forward and I also didn't like that I didn't have redundancy on the spring. I made a...
-
Craig Nedrow reacted to Chris64's post in the thread First real drive! Not tragic but not good. I think I need carb advice. with Like.
Is that what that tank is? OK - so I'm fine to just connect it to an open vacuum line on the carb, right?
