Camar068's latest activity
-
Camar068 replied to the thread Introductions! New member from Florida.Welcome, if in the Destin/FWB area....go eat some wings at Buffalo's Reef for me. -
Camar068 replied to the thread High Pressure Fuel pump install.care to share a pic of the plumbing to the wheel well?
-
I put mine in the wheel well, and have no gas door on the outside of the bed. That really confuses folks.
-
Camar068 replied to the thread Installing Tach in a Non-Ghetto Way?.anyone know if that tach is stock? That's what I'm wanted for my K10. I'll have to start digging again. I know LMC has the 7k rpm...
-
Camar068 reacted to bucket's post in the thread 86 1/2 ton gears needed for 33” with new 383 with
Like.
4:10 minimum. 4.56 ideally. I ran the 700r4/3.73/33" combo for a long time and to be honest, it absolutely sucks. -
Camar068 reacted to Hunter79764's post in the thread Pro Flo 4 with Delphi FE0114 or ACDelco EP381 with Like.
What about a Walbro? Genuine units are good, careful about buying on Amazon or something as the fakes are rampant. That said, I can't...
-
Camar068 reacted to Doppleganger's post in the thread Pro Flo 4 with Delphi FE0114 or ACDelco EP381 with Like.
I went with the EP381 but found something out - there are 2 different 381's and both are in Delco boxes. One is the cheaper ebay ones...
-
Camar068 reacted to TommyGuns's post in the thread Pro Flo 4 with Delphi FE0114 or ACDelco EP381 with Like.
Even if I go with the EP381, that pump is rated less than the "required" flow rate of 57 GPH per the Edelbrock Pro Flo 4 instructions...
-
Camar068 replied to the thread Pro Flo 4 with Delphi FE0114 or ACDelco EP381.EFI I would say yes.
-
Camar068 replied to the thread Pro Flo 4 with Delphi FE0114 or ACDelco EP381.Good luck finding an EP381 let alone for a decent price. I paid $62 for mine 7-8 yrs ago. Well over $100 now at only a few websites...
-
Camar068 replied to the thread Gear Ratio.thx, figured you were getting more than just a gear change...and other variables.
-
Camar068 replied to the thread Mastercraft 31's or 32'.got 6-12 months....when u think about it lol. Planning ahead. Thx Dude
-
Camar068 replied to the thread What new tools have you got lately?.cheap lift for whatever. Bed lift mounted to garage ceiling, deer winch for bed....w/e. Cheapest I've seen it. HF 2000 $55
-
Camar068 replied to the thread New Gas tank installation.hmm....someone design a cheap/efficient 1 button lift to raise the bed 1 foot. Take the bolts out of the bed floor....hit a button...
-
Camar068 replied to the thread Engine & transmission removal & reinstall general tips.nothing meant, but I've always steered clear of adding bolts/chains on the intake especially aluminum. Younger days when intakes hit...
